BUSHNELL, IL —
OSHA Inspection: BUSHNELL ILLINOIS TANK CO.
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of BUSHNELL ILLINOIS TANK CO. in 650 W. DAVIS ST., BUSHNELL, IL 61422 (NAICS 000000). OSHA activity number 303512248.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- BUSHNELL ILLINOIS TANK CO.
- Site address
- 650 W. DAVIS ST.
- City
- BUSHNELL
- State
- IL
- ZIP
- 61422
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 3523
- Employees
- 45
- Ownership type
- A
Citations
15 citations on file for this inspection.
5(a)(1)
- Issued
- Oct 19, 2001
- Abate by
- Dec 7, 2001
- Penalty
- Initial $625 · Current $625
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazard of crushing injuries: On August 9, 2001, employees working south of the Legging Area assembling feed bins were exposed to the hazard of being crushed by a load suspended from the Grove Crane due to the fact that the employer failed to establish and follow a program of frequent and periodic inspections of the crane system. Among other methods, one feasible and acceptable abatement method to correct this hazard is to: a)establish and follow a program of frequent and periodic inspections of the crane system in accordance with ASME B30.5-1994, American Society of Mechanical Engineers for Mobile and Locomotive Cranes, Section 5-2.1.5.
Recent events (2)
- — I (S) $625.00
- — Z (S) $625.00
5(a)(1)
- Issued
- Oct 19, 2001
- Abate by
- Dec 7, 2001
- Penalty
- Initial $1,250 · Current $625 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazard of crushing injuries: On August 9, 2001, employees were exposed to the hazard of being crushed by a load while assembling feed bins: a)Employees working south of the Legging Area used a Harrington Hoist, Serial Number 027974, attached to a Grove Crane for assembly and welding activities and the employer failed to establish and follow a program of frequent and periodic inspections of the hoist system. b)Employees working in the Sheller Area used two Harrington Hoists attached to the tower for assembly and welding activities and the employer failed to establish and follow a program of frequent and periodic inspections of the hoist system. c)Employees working in the Assembly Area used a Dayton Hoist attached to the beams for assembly and welding activities and the employer failed to establish and follow a program of frequent and periodic inspections of the hoist system. Among other methods, one feasible and acceptable abatement method to correct this hazard is to: a)establish and follow a program of frequent and periodic inspections of the hoist system in accordance with ASME B30.16-1998, American Society of Mechanical Engineers for Overhead Hoists (Underhung), Section 16-2.1.5.
Recent events (4)
- — F $153.56
- — Z $5625.00
- — I (S) $625.00
5(a)(1)
- Issued
- Oct 19, 2001
- Abate by
- Dec 7, 2001
- Penalty
- Initial $625 · Current $625
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazard of crushing injuries: On August 9, 2001, employees were exposed to the hazard of being crushed by a load while assembling feed bins: a)Employees working south of the Legging Area used a Harrington Hoist, Serial Number 027974, attached to the Grove Crane to lower feed bins and their components over themselves so they could access the inside for assembly and welding activities. b)Employees working in the Sheller Area used two Harrington Hoists attached to the tower to lower feed bins and their components over themselves so they could access the inside for assembly and welding activities. c)Employees working in the Assembly Area used a Dayton Hoist attached to the beams to lower feed bins and their components over themselves so they could access the inside for assembly and welding activities. Among other methods, one feasible and acceptable abatement method to correct this hazard is to: a)avoid carrying loads over people in accordance with ANSI B30.16-1998, American National Standard for Overhead Hoists (Underhung), Section 16- 3.1.3(i).
Recent events (4)
- — F $153.56
- — Z $5625.00
- — I (S) $625.00
5(a)(1)
- Issued
- Oct 19, 2001
- Abate by
- Nov 23, 2001
- Penalty
- Initial $375 · Current $375
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazard of crushing injuries: On August 16, 2001, employees working south of the Legging Area assembling feed bins were exposed to the hazard of being crushed by a load suspended from the Grove Crane due to the fact that the lifting beam was not marked with the rated load where it was visible and that a nameplate or other permanent marking was not affixed on the lifting beam containing the manufacturer name and address, serial number, lifter weight and the rated load. Among other methods, one feasible and acceptable abatement method to correct this hazard is to: a)mark the rated load of the lifting device on the main structure where it is visible and affix a nameplate or other permanent marking displaying the manufacturer's name and address, serial number, lift weight and rated load in accordance with ASME B30.20-1999, American Society of Mechanical Engineers for Below-the-Hook Lifting Devices, Section 20-1.2.1.
Recent events (2)
- — I (S) $375.00
- — Z (S) $375.00
1910.184 I01
- Issued
- Oct 19, 2001
- Abate by
- Nov 23, 2001
- Penalty
- Initial $500 · Current $500
Recent events (2)
- — I (S) $500.00
- — Z (S) $500.00
1910.184 I09 III
- Issued
- Oct 19, 2001
- Abate by
- Nov 23, 2001
Recent events (2)
- — I (S)
- — Z (S)
1910.212 A05
- Issued
- Oct 19, 2001
- Abate by
- Oct 24, 2001
- Penalty
- Initial $625 · Current $625
Recent events (2)
- — I (S) $625.00
- — Z (S) $625.00
1910.303 B01 III
- Issued
- Oct 19, 2001
- Abate by
- Dec 7, 2001
- Penalty
- Initial $1,250 · Current $1,250
Recent events (2)
- — I (S) $1250.00
- — Z (S) $1250.00
1910.305 G01 IIIA
- Issued
- Oct 19, 2001
- Abate by
- Dec 7, 2001
Recent events (2)
- — I (S)
- — Z (S)
1910.305 G01 IIIB
- Issued
- Oct 19, 2001
- Abate by
- Dec 7, 2001
Recent events (2)
- — I (S)
- — Z (S)
1910.305 G01 IIID
- Issued
- Oct 19, 2001
- Abate by
- Dec 7, 2001
Recent events (2)
- — I (S)
- — Z (S)
1910.334 A02 I
- Issued
- Oct 19, 2001
- Abate by
- Nov 23, 2001
Recent events (2)
- — I (S)
- — Z (S)
1910.178 L01
- Issued
- Oct 19, 2001
- Abate by
- Nov 30, 2001
Recent events (4)
- — F $122.85
- — Z $4500.00
- — I (O)
1910.178 L06
- Issued
- Oct 19, 2001
- Abate by
- Nov 30, 2001
Recent events (2)
- — I (O)
- — Z (O)
1910.303 F
- Issued
- Oct 19, 2001
- Abate by
- Nov 23, 2001
Recent events (2)
- — I (O)
- — Z (O)
More inspections at Bushnell Illinois Tank CO.
View Bushnell Illinois Tank CO.'s full OSHA safety record →
More inspections in this industry (NAICS 000000)
More inspections in IL
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 303512248.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.