OSHA Inspection: CRANE REVOLVING DOOR COMPANY, INC.

Issued

Oct 17, 2005

Abate by

Nov 21, 2005

Penalty

Initial $1,125 · Current $675 Reduced

General-duty citation text

Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not
furnish employment and a place of employment which were free from
recognized hazards that
were causing or likely to cause death or serious physical harm to
employees in that employees
were exposed to:
(a) Hardware Department, East End - The Enco vertical band saw, Serial
Number 36616, used
to cut metal, was not equipped with a magnetic restart or similar device.
The saw was used on
or about September 1, 2005.
(b) Wing Department, East End - The Aarons vertical band saw, Serial
Number 2372, used to
cut metal, was not equipped with a magnetic restart or similar device. The
saw was use on or
about September 9, 2005.
(c) Packing Department, West End - The Sears Craftsman vertical band saw
was not equipped
with a magnetic restart or similar device.  The saw was used on or about
September
12, 2005.
Among other methods, one feasible and acceptable method to correct this
hazard includes but
not limited to the following: Conform to ANSI an American National
Standards Institute for
Metal Sawing Machines B11.10 - 2003, Section 6.11 in that the machine
controls shall
incorporate a type of drive motor starter that will disconnect the drive
motor from the power
source in the event of control voltage or power system failure and to NFPA
a National Fire
Protection Association electrical standard for Industrial Machinery NFPA
79 - 1997, Section
8.14.2 The electrical equipment shall be designed to prevent automatic
restart of any machine
motion or cycles after the power has been restored to required operating
levels.
In accordance with 29 CFR 1903.19(d), abatement certification is required
for this violation
(using the CERTIFICATION OF CORRECTIVE ACTION WORKSHEET), and in
addition, documentation demonstrating that abatement is complete must be
included
with
your certification.  This documentation may include, but not limited to,
evidence of the
purchase or repair of the equipment, photographic or video evidence of
abatement, or other
written records.

Issued

Oct 17, 2005

Abate by

Nov 21, 2005

Penalty

Initial $1,125 · Current $675 Reduced

Issued

Oct 17, 2005

Abate by

Nov 21, 2005

Issued

Oct 17, 2005

Abate by

Dec 23, 2005

Penalty

Initial $900 · Current $500 Reduced

Issued

Oct 17, 2005

Abate by

Nov 21, 2005

Penalty

Initial $1,500 · Current $900 Reduced

Issued

Oct 17, 2005

Abate by

Dec 23, 2005

Penalty

Initial $3,000 · Current $1,750 Reduced