Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: TEAM INDUSTRIAL SERVICES INC

Accident-driven inspection · Safety discipline

On , OSHA opened an accident-driven safety inspection of TEAM INDUSTRIAL SERVICES INC in 8100 BIG LAKE RD, LAKE CHARLES, LA 70605 (NAICS 333999). OSHA activity number 311523906.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Team Industrial Services INC — free Get an email when a new federal OSHA severe-injury report for Team Industrial Services INC is published. One employer, no account, unsubscribe in one click.
Site address
8100 BIG LAKE RD
City
LAKE CHARLES
State
LA
ZIP
70605
Mailing
200 HERMAN DR, ALVIN, TX 77511
Inspection type
Accident-driven (A)
Scope
Partial (B)
Discipline
Safety
Advance notice
Yes
Union status
N
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
333999
SIC code (legacy)
3599
Employees
7
Ownership type
A

1 citation on file for this inspection.

5(a)(1)

Serious Gravity 10 2 instances 4 exposed
Issued
Jul 29, 2008
Abate by
Aug 22, 2008
Penalty
Initial $5,000 · Current $2,500 Reduced
Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not
furnish to each of his employees a place of employment which was free from
recognized hazards
that were causing or likely to cause death or serious physical harm to
employees in that
employees were exposed to a struck-by hazard due to a sudden and violent
release of a nitrogen
pressurized pipe.
On or about 21 April 2008 the employer failed to ensure that a high
pressure gas
line was depressurized prior to machining the cap from the end of it. The
newly
installed gas line at the liquid natural gas (LNG) facility had been
pressure tested
with nitrogen and the failure of the employer to verify line pressures
exposed
employee(s) to a struck-by hazard.
Among other methods, feasible and acceptable abatement could consist of the
development of a Standard Operating Procedure that required direct
measurement
of the pressure in the vessel being machined to verify that it was fully
depressurized and to develop a training program consistent with the
Procedure.
DISCLAIMERS:
1) You are not limited to the abatement methods suggested above.
2) The methods explained are general and may not be effective in all cases.
3) The employer is responsible for selecting and carrying out an
appropriate
method.
Recent events (2)
  • — J (S) $2500.00
  • — Z (S) $5000.00

View Team Industrial Services INC's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 311523906.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.