MORGANTOWN, WV —
OSHA Inspection: WILSON WORKS, INC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of WILSON WORKS, INC. in 202 DISTRIBUTOR DRIVE, MORGANTOWN, WV 26501 (NAICS 332710). OSHA activity number 311679914.
What this inspection record means
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Watch Wilson Works, INC. — free
Get an email when a new federal OSHA severe-injury report for Wilson Works, INC. is published. One employer, no account, unsubscribe in one click.
Where did this inspection happen?
- Establishment
- WILSON WORKS, INC.
- Site address
- 202 DISTRIBUTOR DRIVE
- City
- MORGANTOWN
- State
- WV
- ZIP
- 26501
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 332710
- SIC code (legacy)
- 3599
- Employees
- 30
- Ownership type
- A
Citations
26 citations on file for this inspection.
1910.23 C01
- Issued
- Mar 16, 2009
- Abate by
- Mar 20, 2009
- Penalty
- Initial $1,250 · Current $1,250
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to crushing injuries in the event of crane failure when lifting and lowering loads throughout the shop: (a)Shop Area - Robbin Myers 5 ton underhung crane. Employees were exposed to crushing injuries due to potential hazards such as, but not limited to, crane parts that can become worn, cracked, or distorted and have not been inspected, on or about February 5, 2009. (b)Shop Area - Robbin Myers 5 ton underhung crane. Employees were exposed to crushing injuries due to potential hazards such as, but not limited to, crane parts that can become worn, cracked, or distorted and have not been inspected, on or about February 5, 2009. NOTE: Among other methods, one feasible and acceptable abatement method to correct this hazard is to conduct inspections prior to initial use after installation to insure compliance with the provisions of the standard, as specified by section 11.2.1.1 of the American National Standard, ANSI B30.11-1973, "Monorail Systems and Underhung Cranes". ABATEMENT CERTIFICATION REQUIRED FOR THIS ITEM
1910.37 B02
- Issued
- Mar 16, 2009
- Abate by
- Mar 20, 2009
- Penalty
- Initial $750 · Current $750
General-duty citation text
NOTE: Among other methods, one feasible and acceptable abatement method to correct this hazard is to conduct inspections prior to initial use after installation to insure compliance with the provisions of the standard, as specified by section 11.2.1.1 of the American National Standard, ANSI B30.11-1973, "Monorail Systems and Underhung Cranes". ABATEMENT CERTIFICATION REQUIRED FOR THIS ITEM
1910.107 C06
- Issued
- Mar 16, 2009
- Abate by
- Mar 20, 2009
- Penalty
- Initial $1,000 · Current $1,000
1910.107 C08
- Issued
- Mar 16, 2009
- Abate by
- Mar 20, 2009
1910.107 G07
- Issued
- Mar 16, 2009
- Abate by
- Mar 20, 2009
- Penalty
- Initial $750 · Current $750
1910.134 D01 III
- Issued
- Mar 16, 2009
- Abate by
- Mar 20, 2009
- Penalty
- Initial $1,000 · Current $1,000
Recent events (2)
- — I (S) $1000.00
- — Z (S) $1000.00
1910.134 E01
- Issued
- Mar 16, 2009
- Abate by
- Mar 20, 2009
- Penalty
- Initial $1,000 · Current $1,000
Recent events (2)
- — I (S) $1000.00
- — Z (S) $1000.00
1910.134 F02
- Issued
- Mar 16, 2009
- Abate by
- Mar 20, 2009
- Penalty
- Initial $1,000 · Current $1,000
Recent events (2)
- — I (S) $1000.00
- — Z (S) $1000.00
1910.178 L01 I
- Issued
- Mar 16, 2009
- Abate by
- Mar 20, 2009
- Penalty
- Initial $1,000
Recent events (2)
- — I (O)
- — Z (S) $1000.00
1910.179 J01 I
- Issued
- Mar 16, 2009
- Abate by
- Mar 20, 2009
- Penalty
- Initial $2,500 · Current $2,500
Recent events (2)
- — I (S) $2500.00
- — Z (S) $2500.00
1910.212 A01
- Issued
- Mar 16, 2009
- Abate by
- Mar 20, 2009
- Penalty
- Initial $1,750 · Current $1,750
1910.212 A03 II
- Issued
- Mar 16, 2009
- Abate by
- Jun 1, 2009
- Penalty
- Initial $1,250 · Current $1,250
Recent events (2)
- — I (S) $1250.00
- — Z (S) $1250.00
1910.212 A03 III
- Issued
- Mar 16, 2009
- Abate by
- Mar 20, 2009
- Penalty
- Initial $1,250 · Current $1,250
Recent events (2)
- — I (S) $1250.00
- — Z (S) $1250.00
1910.215 B09
- Issued
- Mar 16, 2009
- Abate by
- Mar 19, 2009
- Penalty
- Initial $635 · Current $635
1910.215 B09
- Issued
- Mar 16, 2009
- Abate by
- Mar 20, 2009
- Penalty
- Initial $750 · Current $750
Recent events (2)
- — I (S) $750.00
- — Z (S) $750.00
1910.219 E03 I
- Issued
- Mar 16, 2009
- Abate by
- Mar 20, 2009
- Penalty
- Initial $1,750 · Current $1,750
1910.219 M01 I
- Issued
- Mar 16, 2009
- Abate by
- Mar 20, 2009
- Penalty
- Initial $750 · Current $750
1910.1200 E01
- Issued
- Mar 16, 2009
- Abate by
- Jun 1, 2009
- Penalty
- Initial $750 · Current $750
Recent events (2)
- — I (S) $750.00
- — Z (S) $750.00
5(a)(1)
- Issued
- Mar 16, 2009
- Abate by
- Mar 20, 2009
- Penalty
- Initial $2,500 · Current $2,500
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to crushing injuries in the event of crane failure when lifting and lowering loads throughout the shop: (a)Shop Area - Robbin Myers 5 ton underhung crane. Employees were exposed to crushing injuries due to potential hazards such as, but not limited to, crane parts that can become worn, cracked, or distorted and have not been inspected, on or about February 5, 2009. (b)Shop Area - Robbin Myers 5 ton underhung crane. Employees were exposed to crushing injuries due to potential hazards such as, but not limited to, crane parts that can become worn, cracked, or distorted and have not been inspected, on or about February 5, 2009. NOTE: Among other methods, one feasible and acceptable abatement method to correct this hazard is to conduct inspections prior to initial use after installation to insure compliance with the provisions of the standard, as specified by section 11.2.1.1 of the American National Standard, ANSI B30.11-1973, "Monorail Systems and Underhung Cranes". ABATEMENT CERTIFICATION REQUIRED FOR THIS ITEM
Recent events (2)
- — I (S) $2500.00
- — Z (S) $2500.00
1910.134 D01 III
- Issued
- Mar 16, 2009
- Abate by
- Mar 20, 2009
- Penalty
- Initial $1,000 · Current $1,000
Recent events (2)
- — I (S) $1000.00
- — Z (S) $1000.00
1910.134 E01
- Issued
- Mar 16, 2009
- Abate by
- Mar 20, 2009
- Penalty
- Initial $1,000
Recent events (2)
- — I (S)
- — Z (S) $1000.00
1910.134 F02
- Issued
- Mar 16, 2009
- Abate by
- Mar 20, 2009
- Penalty
- Initial $1,000
Recent events (2)
- — I (S)
- — Z (S) $1000.00
1910.179 J01 I
- Issued
- Mar 16, 2009
- Abate by
- Mar 20, 2009
- Penalty
- Initial $2,500 · Current $100 Reduced
Recent events (2)
- — I (S) $100.00
- — Z (S) $2500.00
5(a)(1)
- Issued
- Mar 16, 2009
- Abate by
- Mar 20, 2009
- Penalty
- Initial $2,500
Recent events (2)
- — I (S)
- — Z (S) $2500.00
1904.4 A
- Issued
- Mar 16, 2009
- Abate by
- Mar 20, 2009
1910.157 E03
- Issued
- Mar 16, 2009
- Abate by
- Mar 20, 2009
General-duty citation text
to crushing injuries due to potential hazards such as, but not limited to, crane parts that can become worn, cracked, or distorted and have not been inspected, on or about February 5, 2009. (b)Shop Area - Robbin Myers 5 ton underhung crane. Employees were exposed to crushing injuries due to potential hazards such as, but not limited to, crane parts that can become worn, cracked, or distorted and have not been inspected, on or about February 5, 2009. NOTE: Among other methods, one feasible and acceptable abatement method to correct this hazard is to conduct inspections prior to initial use after installation to insure compliance with the provisions of the standard, as specified by section 11.2.1.1 of the American National Standard, ANSI B30.11-1973, "Monorail Systems and Underhung Cranes". ABATEMENT CERTIFICATION REQUIRED FOR THIS ITEM
More inspections at Wilson Works, INC.
View Wilson Works, INC.'s full OSHA safety record →
More inspections in this industry (NAICS 332710)
Jul 16, 2026
Omni Components Corp. · HUDSON, NH
Jul 16, 2026
111613 - FOX Engineering LLC · CAMBRIDGE, MN
Jul 16, 2026
Manson Manufacturing LLC DBA Tomco Manufacturing · WIXOM, MI
Jul 16, 2026
Four WAY Industries INC · CLAWSON, MI
Jul 16, 2026
Four WAY Industries INC · CLAWSON, MI
More inspections in WV
Jul 15, 2026
CDC LLC · SWISS, WV
Jul 15, 2026
Astech Corporation · CHARLESTON, WV
Jul 15, 2026
Unknown · PARKERSBURG, WV
Jul 15, 2026
Phoenix Associates, INC. · VIENNA, WV
Jul 14, 2026
MID Atlantic Metalworks INC. · BRIDGEPORT, WV
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 311679914.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.