JONESBORO, AR —
OSHA Inspection: CRAWFORD CONSTRUCTION
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of CRAWFORD CONSTRUCTION in 2906 KAZI STREET, JONESBORO, AR 72401 (NAICS 238310). OSHA activity number 314489360.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- CRAWFORD CONSTRUCTION
- Site address
- 2906 KAZI STREET
- City
- JONESBORO
- State
- AR
- ZIP
- 72401
- Mailing
- 200 SPARKEY DR, BAY, AR 72411
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238310
- SIC code (legacy)
- 1742
- Employees
- 5
- Ownership type
- A
Citations
3 citations on file for this inspection.
5(a)(1)
- Issued
- Jul 1, 2010
- Abate by
- Jul 6, 2010
- Penalty
- Initial $1,000 · Current $1,000
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to: On or about June 15, 2010, and at times prior thereto, at the jobsite located along Kazi St in Jonesboro, Arkansas where employees were installing stucco cap along the parapet along the roof line of the new Candle Wood Suites. Employees were observed to be exposed to fall hazards while working from a T Trak rough terrain forklift. The employees were working approximately 40 feet above finished grade without the benefit of a fall protection system. The platform had a guard rail and mid rail. However, one employee removed his fall restraint device before the platform was lowered to the ground. Among other methods, feasible and acceptable means of abatement to correct this hazard are to: (1) Require employees working in forklift mounted baskets to wear fall restraint systems. (2) Comply with ANSI B56.6-2005 Section 5.15.1 "Safety Standard for Rough Terrain Forklift Truck Requirements for Elevating Personnel". In accordance with this standard, employees are required to: " be certain that required straining means such as railings, chains, cable, body belt(s) with lanyard(s),etc., are in place and properly used.". Abatement Disclaimers: (1) The employer is not limited to the abatement methods above. (2) The recommended abatement methods may not be effective in all circumstances. (3) The employer is responsible for selecting an appropriate abatement method.nt
1926.501 B01
- Issued
- Jul 1, 2010
- Abate by
- Jul 13, 2010
- Penalty
- Initial $2,000 · Current $2,000
1926.503 C03
- Issued
- Jul 1, 2010
- Abate by
- Jul 13, 2010
More inspections at Crawford Construction
View Crawford Construction's full OSHA safety record →
More inspections in this industry (NAICS 238310)
More inspections in AR
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 314489360.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.