Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: VAIL RESORTS

Referral inspection · Safety discipline

On , OSHA opened a referral safety inspection of VAIL RESORTS in 1599C SUMMIT COUNTY ROAD 3, BRECKENRIDGE, CO 80424 (NAICS 713920). OSHA activity number 330925108.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Vail Resorts — free Get an email when a new federal OSHA severe-injury report for Vail Resorts is published. One employer, no account, unsubscribe in one click.
Establishment
VAIL RESORTS
Site address
1599C SUMMIT COUNTY ROAD 3
City
BRECKENRIDGE
State
CO
ZIP
80424
Mailing
1599C SUMMIT COUNTY ROAD 3, BRECKENRIDGE, CO 80424
Inspection type
Referral (C)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
713920
Employees
18000
Ownership type
A

6 citations on file for this inspection.

5(a)(1)

Deleted Serious Gravity 10 1 instance 3 exposed
Issued
Oct 14, 2011
Abate by
Oct 29, 2011
Penalty
Initial $7,000 · Current $0 Reduced
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to fall hazards:    Vail Resorts, Tower 36, Chair A, 1599C Summit County Road 3, Breckenridge, CO 80424: The employer did not perform a job hazard analysis of a new procedure or document their own procedures when lifting the cable above the eveners to inspect and perform maintenance on the sheaves. On the morning of 7/11/11, an employee fell from tower 36, Chair A while perofmring maintenance on a Riblet lift. The haul rope which was supporting the employee's work chair was severed by the tyne of a forklift. This resulted in an employee falling approximately 21 feet to the ground.    Abatement Note: Among other methods, one feasible and acceptable abatement method to correct this hazard is to perform a job safety (hazard) assessment prior to performing any new rigging operation.    Note:  Abatement certification and documentation are required for this item (see enclosed Certification of Corrective Action Worksheet).
Recent events (2)
  • — I (S) $0
  • — Z (S) $7000

5(a)(1)

Serious Gravity 10 1 instance 3 exposed
Issued
Oct 14, 2011
Abate by
Oct 29, 2011
Penalty
Initial $7,000 · Current $7,000
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to struck-by hazards:    Vail Resorts, Tower 36, Chair A, 1599C Summit County Road 3, Breckenridge, CO 80424: The employer used a sling wrapped around the tyne of a Lull All-Terrain Forklift to lift the haul rope off its sheave assembly. On the morning of 7/11/11, one employee fell from Tower 36, Chair A while on a Riblet Lift when the sling holding the haul rope above the eveners severed against the sharp edges of the forklift tyne and dropped the cable and work chair to the ground. This condition exposed employees to struck-by hazards.    Abatement Note: Among other methods, one feasible and acceptable abatement method to correct this hazard would be to research and contact an additional source who has performed the same task on the same kind of lift in a safe manner.     Abatement Note: ASME B30.9-2010, 9-3.10.4 (d) Rigging Practices- Slings in contact with edges, corners, or protrusions should be protected with a material of sufficient strength, thickness, and construction to prevent damage.    Abatement Note:  Abatement certification and documentation are required for this item (see enclosed Certification of Corrective Action Worksheet).
Recent events (2)
  • — I (S) $7000
  • — Z (S) $7000

1910.178 L04 II E

Deleted Serious Gravity 10 1 instance 1 exposed
Issued
Oct 14, 2011
Abate by
Oct 29, 2011
Penalty
Initial $0 · Current $0
29 CFR 1910.178(l)(4)(ii)(E): The employer failed to evaluate when a condition in the workplace changed in a manner that affected safe operation of the powered industrial truck:    (a) Vail Resorts, Tower 36, Chair A, 1599C Summit County Road 3, Breckenridge, CO 80424:  The employer failed to perform refresher training on the Lull All-Terrain Forklift when the normal procedure for rigging or lifting the haul rope off the cable was not available. This condition resulted iin an employee falling from a height of 21'.     Note:  Abatement certification and documentation are required for this item (see enclosed Certification of Corrective Action Worksheet).
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

5(a)(1)

Other-than-serious 1 instance 3 exposed
Issued
Oct 14, 2011
Abate by
Nov 4, 2011
Penalty
Initial $4,000 · Current $2,500 Reduced
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to fall hazards:    Vail Resorts, Tower 36, Chair A, 1599C Summit County Road 3, Breckenridge, CO 80424: The employer did not perform connector qualification testing on the work chair anchor connectior to verify that it could sustain a force of 5,000 pounds.  This condition exposed employees to a 21' fall hazard.    Abatement Note: Among other methods, one feasible and acceptable abatement method to correct this hazard is to follow ANSI /ASSE Z359.1-2007 Safety Requirements for Personal Fall Areest Systems, Subsystems and Components, Part of the Fall Protection Code., 4.3.6, Anchorage Connector Qualification Testing.    Abatement Note:  Abatement certification and documentation are required for this item (see enclosed Certification of Corrective Action Worksheet).
Recent events (2)
  • — I (O) $2500
  • — Z (S) $4000

1910.132 D01

Other-than-serious 1 instance 3 exposed
Issued
Oct 14, 2011
Abate by
Nov 4, 2011
Penalty
Initial $4,000 · Current $2,500 Reduced
29 CFR 1910.132(d)(1): The employer did not assess the workplace to determine if hazards were present, which necessitate the use of personal protective equipment (PPE).     Vail Resorts, Tower 36, Chair A, 1599C Summit County Road 3, Breckenridge, CO 80424: The employer did not assess the use of fall protection on employees who performed rigging of the haul rope on the Riblet Lift, Tower 36, Chair A.  An employee was not tied off to an anchor point and fell 21'.    Abatement Note:  Abatement certification and documentation are required for this item (see enclosed Certification of Corrective Action Worksheet).
Recent events (2)
  • — I (O) $2500
  • — Z (S) $4000

1910.132 D01 I

Deleted Other-than-serious 1 instance 3 exposed
Issued
Oct 14, 2011
Abate by
Nov 4, 2011
Penalty
Initial $0 · Current $0
29 CFR 1910.132(d)(1)(i): The employer did not select, and have each affected employee use, the types of personal protective equipment (PPE) that will protect the affected employee from the hazards identified in the hazard assessment:    Vail Resorts, Tower 36, Chair A, 1599C Summit County Road 3, Breckenridge, CO 80424: The employer did not select the proper lanyard and harness for fall protection on the Riblet Lift, Tower 36, Chair A.  An employee wearing a standard lanyard and harness fell 21'.  A shock adsorbing lanyard and harness was not used.     Abatement Note:  Abatement certification and documentation are required for this item (see enclosed Certification of Corrective Action Worksheet).
Recent events (2)
  • — I (O) $0
  • — Z (S) $0

View Vail Resorts's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 330925108.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.