Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: ROLANDO'S WELDING & FABRICATING

Referral inspection · Safety discipline

On , OSHA opened a referral safety inspection of ROLANDO'S WELDING & FABRICATING in 1404 E. HWY 44, ROBSTOWN, TX 78380 (NAICS 332420). OSHA activity number 335181582.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Rolando'S Welding & Fabricating — free Get an email when a new federal OSHA severe-injury report for Rolando'S Welding & Fabricating is published. One employer, no account, unsubscribe in one click.
Site address
1404 E. HWY 44
City
ROBSTOWN
State
TX
ZIP
78380
Mailing
P O BOX 1365, ROBSTOWN, TX 78380
Inspection type
Referral (C)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
332420
Employees
7
Ownership type
A

7 citations on file for this inspection.

1910.23 C01

Serious Gravity 5 1 instance 6 exposed
Issued
Dec 21, 2012
Abate by
Feb 6, 2013
Penalty
Initial $2,000 · Current $750 Reduced
29 CFR 1910.23(c)(1):     Open-sided floors and/or platforms four feet or more above adjacent floor or ground level were not guarded with standard railings (or equivalent) and toeboards:    On or about July 13, 2012, at this site, employees were exposed to falls of 4 feet or greater to ground while working on the tops of oilfield frac tanks, where temporary guardrails or equivalent protection was not provided.    Or in the alternative:    Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing, or likely to cause, death or serious physical harm to employees in that employees were exposed to fall hazards:
Recent events (3)
  • — F (S) $750
  • — C (S) $2000
  • — Z (S) $2000

1910.28 A06

Serious Gravity 1 1 instance 1 exposed
Issued
Dec 21, 2012
Abate by
Feb 6, 2013
Penalty
Initial $1,200 · Current $450 Reduced
29 CFR 1910.28(a)(6):     Any scaffold damaged or weakened from any cause was not immediately repaired and not used until repairs had been completed:    On or about July 13, 2012, at this site, employees fabricating on oilfield frac tanks were working from mobile scaffold stands.  One 13-step mobile stand was missing its right hand rail, and one 10-step mobile stand was missing a guard chain at the top work platform.
Recent events (3)
  • — F (S) $450
  • — C (S) $1200
  • — Z (S) $1200

1910.29 A04 II

Serious Gravity 1 1 instance 6 exposed
Issued
Dec 21, 2012
Abate by
Feb 6, 2013
Penalty
Initial $0 · Current $0
29 CFR 1910.29(a)(4)(ii):     Ladder stands did not have at least two (2) of the four (4) casters and were not of the swivel type and provided with a swivel lock to prevent movement:    On or about July 13, 2012, at this site, employees fabricating on oilfield frac tanks were working from mobile scaffold stands which were not provided with a means of locking wheels to prevent unexpected lateral shifting.
Recent events (3)
  • — F (S) $0
  • — C (S) $0
  • — Z (S) $0

1910.178 N07 III

Serious Gravity 1 1 instance 6 exposed
Issued
Dec 21, 2012
Abate by
Feb 6, 2013
Penalty
Initial $1,200 · Current $450 Reduced
29 CFR 1910.178(n)(7)(iii):     On all grades the load and load engaging means were not tilted back if applicable, and raised only as far as necessary to clear the road surface:    On or about July 13, 2012, at this site, employees driving between the frac tank storage and the yard front entrance were observed traveling with the empty forks left raised at between the employee head and waist levels.
Recent events (3)
  • — F (S) $450
  • — C (S) $1200
  • — Z (S) $1200

1910.303 B01 IV

Serious Gravity 5 1 instance 6 exposed
Issued
Dec 21, 2012
Abate by
Feb 6, 2013
Penalty
Initial $1,600 · Current $600 Reduced
29 CFR 1910.303(b)(1)(iv):     Electric equipment was not free from recognized hazards that were likely to cause death or serious physical harm to employees, with the consideration of electrical insulation:    On or about July 13, 2012, at this site, employees fabricating on oilfield frac tanks were using power tools supplied by flexible extension cords with damaged or missing insulation.    Or in the alternative:    29 CFR 1910.303(g)(2)(i)(A):      Except as required or permitted elsewhere in this subpart, live parts of electric equipment operating at 50 volts or more shall be guarded against accidental contact by approved cabinets or other forms of approved enclosures, or other listed means:
Recent events (3)
  • — F (S) $600
  • — C (S) $1600
  • — Z (S) $1600

1910.304 B03 II A

Serious Gravity 5 1 instance 6 exposed
Issued
Dec 21, 2012
Abate by
Feb 6, 2013
Penalty
Initial $2,000 · Current $750 Reduced
29 CFR 1910.304(b)(3)(ii)(A):     All 125-volt, single-phase, 15-, 20-, and 30-ampere receptacle outlets that were not part of the permanent wiring of the building or structure and that were in use by personnel did not have ground-fault circuit-interrupter protection for personnel:    On or about July 13, 2012, at this site in outdoor, semi-covered areas, employees fabricating on oilfield frac tanks were using power tools supplied by 120 volt outlets and flexible power extension cords without GFCI protection.    Or in the alternative:    29 CFR 1910.303(b)(1)(vii):      Electric equipment was not free from recognized hazards that were likely to cause death or serious physical harm to employees, with the consideration of other factors that contribute to the practical safeguarding of persons using or likely to come in contact with the equipment:
Recent events (3)
  • — F (S) $750
  • — C (S) $2000
  • — Z (S) $2000

1910.305 G01 IV A

Serious Gravity 5 1 instance 6 exposed
Issued
Dec 21, 2012
Abate by
Feb 6, 2013
Penalty
Initial $0 · Current $0
29 CFR 1910.305(g)(1)(iv)(A):     Flexible cords and/or cables were used as a substitute for the fixed wiring of a structure:    On or about July 13, 2012, at this site, 120 volt flexible power extension cords were hanging unsupported and draped across the tops of steel frac tanks across adjacent bays, used in place of mounted beam/wall outlets that were out of service.
Recent events (3)
  • — F (S) $0
  • — C (S) $0
  • — Z (S) $0

View Rolando'S Welding & Fabricating's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 335181582.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.