OSHA Inspection: DEFENSE CONTRACT MANAGEMENT AGENCY

Issued

Oct 19, 2012

Abate by

Dec 7, 2012

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.37(a)(3): Exit route(s) were not kept free and unobstructed:      The employer did not ensure that exit routes were kept free and unobstructed by material  or material equipment placed either permanently or temporarily within the exit route.  In the exit route, at two different parts of the facility, expansion leading to the exit door go beyond the handle of the door; obstructing the proper use and operation of the door.

Issued

Oct 19, 2012

Abate by

Oct 25, 2012

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.303(g)(1)(i)(A): For electric equipment operating at 600 volts, nominal, or less to ground, and likely to require examination, adjustment, servicing, or maintenance while energized, the depth of the working space in the direction of access to live parts (as measured from the live parts where they were exposed or from the enclosure front or opening whwere they were enclosed) was less than indicated in Table S-1 of Subpart S of Part 1910:    The employer did not ensure accessable access to the electrical pannel located in the IT room near communications pannel and shelf. It was blocked with material and not accessible.

Issued

Oct 19, 2012

Abate by

Oct 25, 2012

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.305(b)(1)(ii): Unused openings in boxes, cabinets, or fittings were not effectively closed:      The employer did not ensure that all boxes and cabinet fittings were effectively closed to protect employees from electrical hazard in the following locations:    1.In the first floor breakroom an electrical pannel had and unprotected opening,  2.A junction box in the IT room was missing a cover.

Issued

Oct 19, 2012

Abate by

Oct 25, 2012

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.305(b)(2)(i): All pull boxes, junction boxes, and fittings shall be provided with covers identified for the purpose. If metal covers are used, they shall be grounded. In completed installations, each outlet box shall have a cover, faceplate, or fixture canopy. Covers of outlet boxes having holes through which flexible cord pendants pass shall be provided with bushings designed for the purpose or shall have smooth, well-rounded surfaces on which the cords may bear.    On or about 6 Sept 2012, and at times prior thereto, the employer did not ensure that all outlet boxes had covers, faceplates or fixture canopys where a faceplate was missing on a receptacle in the IT room and there was a broken cover in an office.