2,004,209Inspections Most recent open 2026-07-13 Last loaded 2026-07-17
Safety Incidents OSHA Severe Injury Reports · 2015–2025

OSHA Inspection: THE GUNLOCKE COMPANY LLC

Complaint inspection · Health discipline

On , OSHA opened a complaint health inspection of THE GUNLOCKE COMPANY LLC in 1 GUNLOCKE DRIVE, WAYLAND, NY 14572 (NAICS 337211). OSHA activity number 337504815.

Watch THE Gunlocke Company LLC — free Get an email when a new federal OSHA severe-injury report for THE Gunlocke Company LLC is published. One employer, no account, unsubscribe in one click.
Site address
1 GUNLOCKE DRIVE
City
WAYLAND
State
NY
ZIP
14572
Mailing
1 GUNLOCKE DRIVE, WAYLAND, NY 14572
Inspection type
Complaint (B)
Scope
Complete (A)
Discipline
Health
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
337211
Employees
800
Ownership type
A

5 citations on file for this inspection.

1910.134 D01 I

Serious Gravity 5 1 instance 1 exposed
Issued
Penalty
Initial $4250.00 · Current $2763.00 Reduced

Hazardous substances 9135

29 CFR 1910.134(d)(1)(i): Selection of appropriate respirators was not based on the respiratory hazard(s) to which the worker was exposed and user factors that affect respirator performance and reliability.     a)  Chair Sanding Area, on or about 12/19/12:  The employer did not select and provide an appropriate respirator for employee whose exposure exceeded the permissible exposure limit for total dust.  Employee exposure as referenced in Citation 1 Item 1b.
Recent events (2)
  • — I (S) $2762.5
  • — Z (S) $4250

1910.1000 C

Serious Gravity 5 1 instance 1 exposed
Issued
Penalty
Initial $0.00 · Current $0.00

Hazardous substances 9135

29 CFR 1910.1000(c):  Employees were exposed to materials in excess of the eight hour permissible exposure limit, listed in Table Z-3 of subpart Z of 29 CFR part 1910:    a)  Chair Sanding Area, on or about 12/19/12:  An employee sanding chairs was exposed to 28.447 milligrams per cubic meter (mg/m3) of total dust, eight hour time weighted average (TWA), approximately 1.90 times the OSHA permissible exposure limit of 15.0 mg/m3. The sampling period was for 457 minutes. A zero increment is included for the 23 minutes not sampled. Employee was not wearing a half mask air purifying respirator.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1910.1000 E

Serious Gravity 5 1 instance 1 exposed
Issued
Penalty
Initial $0.00 · Current $0.00

Hazardous substances 9135

29 CFR 1910.1000(e):  Feasible administrative or engineering controls were not determined and implemented to achieve compliance with the limits prescribed in 29 CFR 1910.1000(a) through (d):    a)  Chair Sanding Area, on or about 12/19/13:   Feasible administrative or engineering controls were not implemented to reduce employee exposure to total dust below the OSHA Permissible Exposure Limit. Employee exposure as referenced in Citation 1 Item 1b.    EFFECTIVE MEANS OF ABATEMENT INCLUDE BUT ARE NOT LIMITED TO:    1. Provide local exhaust ventilation at point of operation    2. Re-examine the dust collection system    3. Train employees on methods to avoid unnecessary exposure     4. Conduct air monitoring after any changes have been made to determine if improvements have been made.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1910.107 G02

Serious Gravity 5 1 instance 1 exposed
Issued
Penalty
Initial $3400.00 · Current $2210.00 Reduced
29 CFR 1910.107(g)(2):  Spraying area(s) were not kept free from the accumulation of deposits of combustible residues:    a)  UCell Area, on or about 11/27/13: There was an accumulation of combustible residues on the spraying racks/fixtures/trucks and these fixtures are used to carry parts that employee spray paint with flammable materials.
Recent events (2)
  • — I (S) $2210
  • — Z (S) $3400

1910.1026 D01

Other-than-serious 1 instance 1 exposed
Issued
Penalty
Initial $0.00 · Current $0.00
29 CFR 1910.1026(d)(1): Each employer shall determine the 8-hour time weighted average (TWA) exposure for each employee exposed to chromium (VI):    a)  Maintenance Area, on or about 2/26/13: Exposure to chromium (VI) was not determined for employees making repairs on bending pans containing stainless steel.
Recent events (2)
  • — I (O) $0
  • — Z (O) $0

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 337504815.