JACKSONVILLE, FL —
OSHA Inspection: RCP SERVICES, INC
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of RCP SERVICES, INC in 5000 BIG ISLAND DRIVE, JACKSONVILLE, FL 32246 (NAICS 236116). OSHA activity number 337728430.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- RCP SERVICES, INC
- Site address
- 5000 BIG ISLAND DRIVE
- City
- JACKSONVILLE
- State
- FL
- ZIP
- 32246
- Mailing
- P.O. BOX 4577, SARATOGA SPRINGS, NY 12866
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 236116
- Employees
- 25
- Ownership type
- A
Citations
5 citations on file for this inspection.
1926.501 B01
- Issued
- Mar 12, 2013
- Penalty
- Initial $2,800 · Current $2,800
General-duty citation text
29 CFR 1926.501(b)(1): Each employee on a walking/working surface with an unprotected side or edge which was 6 feet (1.8 m) or more above a lower level was not protected from falling by the use of guardrail systems, safety net systems, or personal fall arrest systems: a. On or about December 6, 2012, on the 4th floor, an employee was working near an unprotected edge without the use of guardrail systems, safety nets, or personal fall arrest, exposing himself to a 40-foot fall hazard. b. On or about December 6, 2012, on the 2nd floor, an employee was setting concrete form shoring near an unprotected edge without the use of guardrail systems, safety nets, or personal fall arrest, exposing himself to a 20-foot fall hazard. c. On or about December 6, 2012, on the 2nd floor, 2 employees were welding steel columns in place near an unprotected edge without the use of guardrail systems, safety nets, or personal fall arrest, exposing themselves to a 20-foot fall hazard. d. On or about December 6, 2012, on the 2nd floor, 2 employees were sweeping and chipping concrete splatter off of the deck near unprotected edges without the use of guardrail systems, safety nets, or personal fall arrest, exposing themselves to a 20-foot fall hazard.
Recent events (1)
- — Z (S) $2800
1926.501 B04 I
- Issued
- Mar 12, 2013
- Penalty
- Initial $1,600 · Current $1,600
General-duty citation text
29 CFR 1926.501(b)(4)(i): Each employee on walking/working surfaces was not protected from falling through holes (including skylights), more than six feet (1.8 m) above lower levels, by personal fall arrest systems, covers, or guardrail systems erected around such holes: a. On or about December 6, 2012, on the 2nd floor, there were several rectangle stair way holes approximately 8 by 10 feet wide, exposing employees to a 10-feet fall hazard.
Recent events (1)
- — Z (S) $1600
1926.501 B04 II
- Issued
- Mar 12, 2013
- Penalty
- Initial $1,600 · Current $1,600
General-duty citation text
29 CFR 1926.501(b)(4)(ii): Each employee on a walking/working surface was not protected from tripping in or stepping into or through holes (including skylights) by covers: a. On or about December 6, 2012, on the 2nd floor, near the job made ladder access there was a rectangle hole 8 by 8 inches wide unprotected, exposing employees to tripping hazard.
Recent events (1)
- — Z (S) $1600
1926.701 B
- Issued
- Mar 12, 2013
- Penalty
- Initial $2,000 · Current $2,000
General-duty citation text
29 CFR 1926.701(b): All protruding reinforcing steel, onto and/or into which employees could fall or come against, was not guarded to eliminate the hazard of impalement: a. On or about December 6, 2012, on the 2nd floor, there was unportected rebar protruding from the floor, exposing employees to an impalment hazard.
Recent events (1)
- — Z (S) $2000
1926.1053 B10
- Issued
- Mar 12, 2013
- Penalty
- Initial $1,600 · Current $1,600
General-duty citation text
29 CFR 1926.1053(b)(10): The tops of a non-self-supporting ladder were not placed with the two rails supported equally: a. On or about December 6, 2012, the ladder used to access the 2nd floor was not secured, exposing employees to a 10-feet fall hazard.
Recent events (1)
- — Z (S) $1600
More inspections at RCP Services, INC
View RCP Services, INC's full OSHA safety record →
More inspections in this industry (NAICS 236116)
More inspections in FL
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 337728430.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.