LEWES, DE —
OSHA Inspection: MAGNO CARPENTRY, INC.
Referral inspection · Safety discipline
At a glance
On , OSHA opened a referral safety inspection of MAGNO CARPENTRY, INC. in BLDG #15 BETHPAGE DRIVE HERITAGE VILLAGE, LEWES, DE 19958 (NAICS 238130). OSHA activity number 339011934.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- MAGNO CARPENTRY, INC.
- Site address
- BLDG #15 BETHPAGE DRIVE HERITAGE VILLAGE
- City
- LEWES
- State
- DE
- ZIP
- 19958
- Mailing
- 18456 GRAVEL HILL ROAD, GEORGETOWN, DE 19947
What kind of inspection was it?
- Inspection type
- Referral (C)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- Employees
- 6
- Ownership type
- A
Citations
2 citations on file for this inspection.
5(a)(1)
- Issued
- Jul 1, 2013
- Abate by
- Jul 8, 2013
- Penalty
- Initial $2,520 · Current $1,754 Reduced
General-duty citation text
OSH ACT of 1970 Section (5)(a)(1): The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to death and serious injuries from a substandard suspended unguarded platform: a) On or about April 16, 2013, employees, with no fall protection, were lifted up on a wooden pallet of the forklift, approximately 20', in order to unload roofing materials. The wood pallet did not conform to the American National Standard ITSDF B56.1-2012, Safety Standard for Low and High Lift Trucks; section 4.17, Elevating Personnel, Only operator-up high lift trucks have been designed to lift personnel. If a work platform is used on trucks designed and intended for handling materials, the requirements in paragraph 4.17.2 and 4.17.3 shall be met for lifting personnel. Employees were exposed to a 20' fall hazard when lifted on the pallet, on the fork(s) of the forklift. Among other methods, feasible and acceptable means to correct this hazard would be to: follow guidelines listed in ITSDF B56.1-2012, use a device that has been designed to lift personnel with an approved work platform or ensure that employees use an appropriate ladder or scissor lift.
Recent events (2)
- — I (S) $1754
- — Z (S) $2520
1926.501 B13
- Issued
- Jul 1, 2013
- Penalty
- Initial $2,520 · Current $1,754 Reduced
General-duty citation text
29 CFR 1926.501(b)(13): Each employee engaged in residential construction activities 6 feet or more above lower levels was not protected by guardrail systems, safety net system, or personal fall arrest system: a) Bldg #15 Bethpage Drive, Heritage Village, Lewes, DE - Employees observed working on a 10/12 pitch roof of a residential construction site, approximately 20-25 feet above the ground, without adequate fall protection. The employees were installing roof sheathing without being tied off to the harness. This exposed the employees to fall hazards. The violation was observed on or about April 16, 2013.
Recent events (2)
- — I (S) $1754
- — Z (S) $2520
More inspections at Magno Carpentry, INC.
View Magno Carpentry, INC.'s full OSHA safety record →
More inspections in this industry (NAICS 238130)
More inspections in DE
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 339011934.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.