FITZGERALD, GA ·
OSHA Inspection: GILMAN BUILDING PRODUCTS, LLC
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of GILMAN BUILDING PRODUCTS, LLC in 173 PEACHTREE ROAD, FITZGERALD, GA 31750 (NAICS 321113). OSHA activity number 339217325.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- GILMAN BUILDING PRODUCTS, LLC
- Site address
- 173 PEACHTREE ROAD
- City
- FITZGERALD
- State
- GA
- ZIP
- 31750
- Mailing
- P.O. BOX 310, FITZGERALD, GA 31750
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (B)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 321113
- Employees
- 140
- Ownership type
- Private (A)
Citations
4 citations on file for this inspection.
1910.23 D01 III
- Issued
- Jan 14, 2014
- Penalty
- Initial $2,168 · Current $3,630
General-duty citation text
29 CFR 1910.23(d)(1)(iii): Stairway(s) less than 44 inches wide having both sides open, did not have one stair railing on each side: a) Planer Room Stairs - On or about July 18, 2013, the employer did not ensure that the six riser stairway leading over the planer was equipped with a standard stair railing on both open sides, exposing employees to fall hazards of up to 4 feet. ABATEMENT CERTIFICATION IS NOT REQUIRED
Recent events (2)
- · I (O) $3630
- · Z (S) $2168
1910.178 P01
- Issued
- Jan 14, 2014
- Penalty
- Initial $5,100 · Current $3,630 Reduced
General-duty citation text
29 CFR 1910.178(p)(1): Powered industrial truck(s) found to be in need of repair, defective, or in any way unsafe had not been taken out of service until restored to safe operating condition(s): a) Throughout Sawmill - On or about July 18, 2013 and times prior to, employees vision was impaired while operating the Taylor T360 powered industrial truck (forklift) identified as #310 with cracked front and side windshields that had not been withdrawn from service until restored to safe operating conductions, exposing employees to struck-by hazards. b) Throughout Sawmill - On or about July 18, 2013 and times prior to, employees vision was impaired while operating the Taylor T360 powered industrial truck (forklift) identified as #311 with cracked front and side windshields that had not been withdrawn from service until restored to safe operating conductions, exposing employees to struck-by hazards. c) Throughout Sawmill - On or about July 18, 2013 and times prior to, employees vision was impaired while operating the Taylor T360 powered industrial truck (forklift) identified as #312 with cracked front and side windshields that had not been withdrawn from service until restored to safe operating conductions, exposing employees to struck-by hazards. ABATEMENT CERTIFICATION IS NOT REQUIRED
Recent events (2)
- · I (O) $3630
- · Z (S) $5100
1910.265 C18 II
- Issued
- Jan 14, 2014
- Penalty
- Initial $3,613 · Current $3,620
General-duty citation text
29 CFR 1910.265(c)(18)(ii): Spiked live rolls on live roll conveyor(s) were not guarded: a) West Transfer Deck - On or about July 18, 2013, the employer did not ensure that the end of the west transfer deck in-feed conveyor to Debarker #1 was guarded to prevent exposure to an in-running nip point, exposing employees to amputation hazards. ABATEMENT CERTIFICATION IS NOT REQUIRED
Recent events (2)
- · I (O) $3620
- · Z (S) $3613
1910.23 C01
- Issued
- Jan 14, 2014
- Penalty
- Initial $20,000 · Current $7,000 Reduced
General-duty citation text
29 CFR 1910.23(c)(1): Open-sided floors and/or platforms four feet or more above adjacent floor or ground level were not guarded with standard railings (or equivalent) and toeboards: a) Vertical Double Augar - On or about July 18, 2013, the employer did not ensure that the vertical double auger platform was fully enclosed by guardrails, exposing employees to fall hazards of up to 7 feet. ABATEMENT CERTIFICATION IS NOT REQUIRED Gilman Building Products, LLC was previously cited for a violation of this occupational safety and health standard or its equivalent standard [29 CFR 1910.23(c)(1)], which was contained in OSHA inspection number 315480665, citation number 1, item number 1a and was affirmed as a final order on December 20, 2011 with respect to a workplace located at 6640 County Road 218, Jacksonville, FL 32234.
Recent events (2)
- · I (S) $7000
- · Z (R) $20000
More inspections at Gilman Building Products, LLC
View Gilman Building Products, LLC's full OSHA safety record →
More inspections in this industry (NAICS 321113)
More inspections in GA
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 339217325.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.