CLEVELAND, GA —
OSHA Inspection: ATLANTA HARDWOOD CORPORATION
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of ATLANTA HARDWOOD CORPORATION in 176 APPALACHIAN TRAIL, CLEVELAND, GA 30528 (NAICS 321918). OSHA activity number 339248890.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- ATLANTA HARDWOOD CORPORATION
- Site address
- 176 APPALACHIAN TRAIL
- City
- CLEVELAND
- State
- GA
- ZIP
- 30528
- Mailing
- 176 APPALACHIAN TRAIL, CLEVELAND, GA 30528
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 321918
- Employees
- 51
- Ownership type
- A
Citations
5 citations on file for this inspection.
1910.36 G02
- Issued
- Dec 16, 2013
- Abate by
- Jan 13, 2014
- Penalty
- Initial $3,060 · Current $1,836 Reduced
General-duty citation text
29 CFR 1910.36(g)(2): Exit access(es) were not at least 28 inches (71.1 cm) wide at all points. On or about July 30, 2013: a) Employees were exposed to fire and smoke hazards while working in an area of machinery where the exit route from the machinery measured an approximate 17 inches in width.
Recent events (2)
- — I (S) $1836
- — Z (S) $3060
1910.133 A01
- Issued
- Dec 16, 2013
- Abate by
- Dec 20, 2013
- Penalty
- Initial $2,295 · Current $1,377 Reduced
General-duty citation text
29 CFR 1910.133(a)(1): The employer did not ensure that each affected employee uses appropriate eye or face protection when exposed to eye or face hazards from flying particles, molten metal, liquid chemicals, acids or caustic liquids, chemical gases or vapors, or potentially injurious light radiation On or about July 30, 2013: (a) Employees were exposed to eye injuries while working around the MJ 31 Rip saw, when the class III laser was not properly shielded or barricaded, which allowed the laser to extend across the walking aisle for employees.
Recent events (2)
- — I (S) $1377
- — Z (S) $2295
1910.147 C04 II B
- Issued
- Dec 16, 2013
- Abate by
- Jan 13, 2014
- Penalty
- Initial $3,825 · Current $0 Reduced
General-duty citation text
29 CFR 1910.147(c)(4)(ii)(B): The energy control procedure did not clearly and specifically specific procedural steps for shutting down, isolating, blocking and securing machines or equipment to control hazardous energy: On or about July 30, 2013; a) Employees were exposed to amputation hazards while performing operations on in feed, gang-rip, out feed, conveyors and saw machinery, where the written specific lock out tag out procedures failed to address procedures for eliminating potential release of energy.
Recent events (2)
- — I (S) $0
- — Z (S) $3825
1910.213 A09
- Issued
- Dec 16, 2013
- Abate by
- Dec 20, 2013
- Penalty
- Initial $3,060 · Current $1,836 Reduced
General-duty citation text
29 CFR 1910.213(a)(9): All belts, pulleys, gears, shafts, and moving parts were not guarded in accordance with the specific requires of 1910.219: On or about July 30, 2013: (a) Employees were exposed to caught in hazards while working around a chain transfer table located by the MJ 31 Rip Saw that had ingoing nip points that were not properly guarded. (b) Employees were exposed to caught in hazards while working around a chain transfer table located at the end of the conveyer line, that had ingoing nip points that were not properly guarded.
Recent events (2)
- — I (S) $1836
- — Z (S) $3060
1910.303 G01
- Issued
- Dec 16, 2013
- Abate by
- Jan 13, 2014
- Penalty
- Initial $4,590 · Current $0 Reduced
General-duty citation text
29 CFR 1910.303(g)(1): Sufficient access and working space was not provided and maintained about all electric equipment (operating at 600 volts, nominal, or less to ground) to permit ready and safe operation and maintenance of such equipment: On or about July 30, 2013: (a) Employees were exposed to injuries while working on machinery when the electrical boxes containing shut offs were blocked by conveyer line transporting stock to various other project spaces within the rough mill area.
Recent events (2)
- — I (S) $0
- — Z (S) $4590
More inspections at Atlanta Hardwood Corporation
View Atlanta Hardwood Corporation's full OSHA safety record →
More inspections in this industry (NAICS 321918)
More inspections in GA
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 339248890.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.