Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,196,249Inspections Most recent open 2026-08-20 Last loaded 2026-08-24

OSHA Inspection: HELMERICH & PAYNE INTERNATIONAL DRILLING CO. RIG 299

Planned inspection · Health discipline

On , OSHA opened a planned health inspection of HELMERICH & PAYNE INTERNATIONAL DRILLING CO. RIG 299 in 2.8 MILES S. OF NIXON ON HWY 80 DIESTE UNIT #1H, NIXON, TX 78140 (NAICS 213111). OSHA activity number 339641854.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Helmerich & Payne International Drilling CO. RIG 299 for free Get an email when a new federal OSHA severe-injury report for Helmerich & Payne International Drilling CO. RIG 299 is published. One employer, no account, unsubscribe in one click.
Site address
2.8 MILES S. OF NIXON ON HWY 80 DIESTE UNIT #1H
City
NIXON
State
TX
ZIP
78140
Mailing
1437 S. BOULDER AVE., TULSA, OK 74119
Inspection type
Planned (H)
Scope
Complete (A)
Discipline
Health
Advance notice
No
Union status
Non-union (B)
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
213111
Employees
8
Ownership type
Private (A)

2 citations on file for this inspection.

1910.252 B04 IV

Serious Gravity 1 1 instance 2 exposed
Issued
Aug 28, 2014
Abate by
Sep 8, 2014
Penalty
Initial $3,000 · Current $1,800 Reduced
29 CFR 1910.252(b)(4)(iv): An attendant with a preplanned rescue procedure was not stationed outside a confined space opening to observe the welder at all times in case of emergency:  At the Rig 299 drilling site located at Dieste Unit #1H well near Nixon, Texas, on or about March 13, 2014, where employees and contractor(s) were engaged in operations to install the well head, rescue procedures had not been preplanned while a contract welder entered the cellar, a confined space more than 5 feet deep, to pump out water and cut the conductor pipe with an oxy-acetylene torch, exposing employee(s) to the hazards of delayed rescue. Although the employer does not permit employees to perform entry rescue, a retrieval system such as a lifeline attached to a mechanical device was not provided to facilitate non-entry rescue.
Recent events (2)
  • · I (S) $1800
  • · Z (S) $3000

1910.1200 F06

Serious Gravity 1 1 instance 8 exposed
Issued
Aug 28, 2014
Abate by
Sep 8, 2014
Penalty
Initial $3,000 · Current $1,800 Reduced

Hazardous substances D150

29 CFR 1910.1200(f)(6): The employer did not ensure that each container of hazardous chemicals in the workplace was labeled, tagged or marked with the information specified under paragraphs (f)(6)(i) through (ii) of this section:  At the Rig 299 drilling site located at Dieste Unit #1H well near Nixon, Texas, on March 13, 2014 and at times prior thereto containers for chemicals used in drilling operations and/or fueling of equipment were not labeled with health hazard warnings, including but not limited to, skid-mounted totes labeled Lube Oil, Anti-Freeze, and Gear Oil,  the skid-mounted diesel fuel tank, the HPU diesel tank, and Red Eagle safety cans containing Diesel Fuel, which were also not labeled with contents, exposing employees to the hazards of chemicals.
Recent events (2)
  • · I (S) $1800
  • · Z (S) $3000

View Helmerich & Payne International Drilling CO. RIG 299's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 339641854.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.