Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: MIGUEL SALDANA

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of MIGUEL SALDANA in 4525 ACKERLY FARM ROAD, NEW ALBANY, OH 43054 (NAICS 238130). OSHA activity number 340051713.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Miguel Saldana — free Get an email when a new federal OSHA severe-injury report for Miguel Saldana is published. One employer, no account, unsubscribe in one click.
Establishment
MIGUEL SALDANA
Site address
4525 ACKERLY FARM ROAD
City
NEW ALBANY
State
OH
ZIP
43054
Mailing
40 ELDON AVENUE, COLUMBUS, OH 43204
Inspection type
Planned (H)
Scope
Complete (A)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
4
Ownership type
A

3 citations on file for this inspection.

1926.501 B13

Serious Gravity 10 1 instance 3 exposed
Issued
Nov 19, 2014
Penalty
Initial $2,800 · Current $1,960 Reduced
29 CFR 1926.501(b)(13): "Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure. Exception: When the employer can demonstrate that it is infeasible or creates a greater hazard to use these systems, the employer shall develop and implement a fall protection plan which meets the requirements of paragraph (k) of 1926.502. Note: There is a presumption that it is feasible and will not create a greater hazard to implement at least one of the above-listed fall protection systems. Accordingly, the employer has the burden of establishing that it is appropriate to implement a fall protection plan which complies with 1926.502(k) for a particular workplace situation, in lieu of implementing any of those systems.  a. On the garage roof of the house where employees were installing Tyvek to the exterior of the house, fall protection was not used, thereby exposing the employees to a 15 foot fall hazard.
Recent events (2)
  • — I (S) $1960
  • — Z (S) $2800

1926.1053 B01

Serious Gravity 5 1 instance 2 exposed
Issued
Nov 19, 2014
Penalty
Initial $1,600 · Current $1,120 Reduced
29 CFR 1926.1053(b)(1): When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support.   a. On the front of the garage where employees used a non-self-supporting extension ladder to gain access to the fifteen foot high roof, the ladder did not extend at least three feet above the landing surface, thereby exposing employees to a fall hazard.
Recent events (2)
  • — I (S) $1120
  • — Z (S) $1600

1926.1053 B05 I

Serious Gravity 5 1 instance 2 exposed
Issued
Nov 19, 2014
Penalty
Initial $1,600 · Current $1,120 Reduced
29 CFR 1926.1053(b)(5)(i): Non-self-supporting ladders shall be used at an angle such that the horizontal distance from the top support to the foot of the ladder is approximately one-quarter of the working length of the ladder (the distance along the ladder between the foot and the top support).  a. On the front of the garage where employees used a non-self-supporting ladder to gain access to the fifteen foot high roof, the ladder was placed 14 feet, 4 inches away from the wall, thereby exposing employees to a fall hazard.
Recent events (2)
  • — I (S) $1120
  • — Z (S) $1600

View Miguel Saldana's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 340051713.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.