Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: DYER ROOFING & SHEET METAL CO., INC.

Unprogrammed Other inspection · Safety discipline

On , OSHA opened an unprogrammed Other safety inspection of DYER ROOFING & SHEET METAL CO., INC. in 1530 JOY LANE, DECATUR, GA 30032 (NAICS 238160). OSHA activity number 340607100.

Watch Dyer Roofing & Sheet Metal CO., INC. — free Get an email when a new federal OSHA severe-injury report for Dyer Roofing & Sheet Metal CO., INC. is published. One employer, no account, unsubscribe in one click.
Site address
1530 JOY LANE
City
DECATUR
State
GA
ZIP
30032
Mailing
1200 MARLER STREET, GAINESVILLE, GA 30501
Inspection type
Unprogrammed Other (I)
Scope
Complete (A)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238160
Employees
20
Ownership type
A

3 citations on file for this inspection.

1926.25 A

Serious Gravity 10 1 instance 12 exposed
Issued
Sep 4, 2015
Abate by
Sep 17, 2015
Penalty
Initial $3,080 · Current $1,500 Reduced
29 CFR 1926.25(a): During the course of construction, alteration, or repairs, debris was not kept cleared from work areas, passageways, and stairs, in and around buildings or other structures:  On or about 04/23/2015, at 1530 Joy Lane, Decatur, GA; employees performing tarring operations were exposed to falling onto building material debris including but not limited to brick, block, wood, and metals that were not properly cleaned up from the ground.
Recent events (2)
  • — I (S) $1500
  • — Z (S) $3080

1926.502 H01 V

Deleted Serious Gravity 10 3 instances 10 exposed
Issued
Sep 4, 2015
Abate by
Sep 17, 2015
Penalty
Initial $3,080 · Current $0 Reduced
29 CFR 1926.502(h)(1)(v): The safety monitor had other responsibilities which could take the monitor's attention from  the monitoring function:  On or about 4/28/2015, at 1530 Joy Lane, Decatur, GA; where the measurement of the parapet walls were 2 CMU's high (approximately 26 inches), two employees performing roof sealing activities and were observed as being exposed to:  a. 33 foot falls to the scaffold walking boards below, or  b. 43 feet, one and one half inch (1.5") falls to the lower level if beyond scaffold below, or   c. approximately 27 foot impalement hazards below on the tips of the ladder jack scaffolds where the monitor was performing tasks other than monitoring.
Recent events (2)
  • — I (S) $0
  • — Z (S) $3080

1926.501 B10

Repeat Gravity 10 3 instances 10 exposed
Issued
Sep 4, 2015
Abate by
Sep 17, 2015
Penalty
Initial $53,900 · Current $28,500 Reduced
29 CFR 1926.501(b)(10): Each employee engaged in roofing activities on low-slope roofs with unprotected sides and edges 6 feet or more above lower levels, was not protected from falling by guardrail systems, safety net systems, personal fall arrest systems, or a combination of warning line system and guardrail system, warning line system and safety net system, or warning line system and personal fall arrest system, or warning line system and safety monitoring system.  Or, on roofs 50-feet (15.25 m) or less in width, each employee was not protected by use of a monitoring system:  On or about 4/28/2015, at 1530 Joy Lane, Decatur, GA; where two employees were observed performing roof tarring activities on a 77 foot wide flat roof and were exposed to:  a. 33 foot fall to the scaffold walking boards below, or  b. 43 feet, one and one half inch (1.5") fall to the lower level if beyond scaffold below, or   c. approximately 27 foot impalement hazard below on the tips of the ladder jack scaffolds where the employees were not wearing fall protection and were not connected.  Dyer Roofing & Sheet Metal Co., Inc. was previously cited REPEAT for a violation of this occupational safety and health standard or its equivalent standard 1926.501(b)(1), which was contained in OSHA inspection number 314206913, citation number 2, item number 1 and was affirmed as a final order on 2/25/2011, with respect to a workplace located at 1221 Lawrenceville Highway, Lawrenceville, GA.
Recent events (2)
  • — I (R) $28500
  • — Z (R) $53900

View Dyer Roofing & Sheet Metal CO., INC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 340607100.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.