Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: N. GRANESE & SONS, INC

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of N. GRANESE & SONS, INC in MARSHALL ROAD, WINCHESTER, MA 01890 (NAICS 237110). OSHA activity number 340768340.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch N. Granese & Sons, INC — free Get an email when a new federal OSHA severe-injury report for N. Granese & Sons, INC is published. One employer, no account, unsubscribe in one click.
Site address
MARSHALL ROAD
City
WINCHESTER
State
MA
ZIP
01890
Mailing
59 JEFFERSON AVE, SALEM, MA 01970
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
237110
Employees
30
Ownership type
A

6 citations on file for this inspection.

1926.21 B02

Serious Gravity 5 4 instances 4 exposed
Issued
Aug 5, 2015
Abate by
Aug 24, 2015
Penalty
Initial $3,150 · Current $2,000 Reduced
29 CFR 1926.21(b)(2): The employer did not instruct each employee in the recognition and avoidance of unsafe conditions and the regulations applicable to his/her environment to control or eliminate any hazards or other exposure to illness or injury:    On or about July 9, 2015 the employer failed to adequately train employees in recognition and avoidance of trench hazards, rigging equipment and trench protective systems.    Instance A: Rigging equipment inspections for load rating tags permanently attached to chain slings for various hitch types.  Instance B: Weights of material to be rigged and move by mechanical equipment (trench box/shield).  Instance C: Depth requirements for ladders for safe entry and exit into trenches greater than four feet in depth.  Instance D: Trench box/shield systems manufacturer's tabulated data and assembly instructions for required system components (spreader pins).  Instance E:  Determine if was necessary to monitor for harmful levels of atmospheric contaminants that could be released from damaged sewer pipes.
Recent events (2)
  • — I (S) $2000
  • — Z (S) $3150

1926.651 C02

Serious Gravity 5 1 instance 1 exposed
Issued
Aug 5, 2015
Penalty
Initial $3,150 · Current $2,000 Reduced
29 CFR 1926.651(c)(2): A stairway, ladder, ramp or other safe means of egress was not located in trench excavations that were 4 feet (1.22m) or more in depth so as to require no more than 25 feet (7.62m) of lateral travel for employees      Marshall Road Worksite  On or about July 9, 2015 an employee was exposed to cave-in hazards, and slip and fall hazards while climbing the trench side-walls to enter and exit a six-foot deep trench with straight cut earthen walls where a ladder was not provided in the trench for access and egress.
Recent events (2)
  • — I (S) $2000
  • — Z (S) $3150

1926.652 A01

Serious Gravity 10 1 instance 1 exposed
Issued
Aug 5, 2015
Penalty
Initial $4,410 · Current $2,500 Reduced
29 CFR 1926.652(a)(1): Each employee in an excavation was not protected from cave-ins by an adequate protective system designed in accordance with 29 CFR 1926.652(b) or (c).     Marshall Road Worksite  On or about July 9, 2015 an employee was exposed to trench cave-in hazards while performing pipe inspection and repair/replacement/relocation activities in a 6-foot, 7-inch deep trench with straight cut earthen walls without an adequate protective system in place.
Recent events (2)
  • — I (S) $2500
  • — Z (S) $4410

1926.1053 B04

Serious Gravity 5 1 instance 3 exposed
Issued
Aug 5, 2015
Penalty
Initial $2,520 · Current $1,500 Reduced
29 CFR 1926.1053(b)(4): Ladder(s) were used for purposes other than the purpose for which they were designed    Marshall Road Worksite  On or about July 9, 2015 the top section of a two-piece extension ladder was onsite for use to enter and exit trenches.
Recent events (2)
  • — I (S) $1500
  • — Z (S) $2520

1926.1053 B15

Serious Gravity 5 1 instance 3 exposed
Issued
Aug 5, 2015
Abate by
Aug 11, 2015
Penalty
Initial $0 · Current $0
29 CFR 1926.1053(b)(15): Ladders shall be inspected by a competent person for visible defects on a periodic basis and after any occurrence that could affect their safe use.  Marshall Road Worksite On or about July 9, 2015 the top section of a two-piece extension ladder was not inspected to determine the load rating and the manufacturer's instructions for separating the extension sections for separate use.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.1060 A

Serious Gravity 5 1 instance 4 exposed
Issued
Aug 5, 2015
Abate by
Aug 24, 2015
Penalty
Initial $0 · Current $0
29 CFR 1926.1060(a): The employer did not provide a training program for each employee using ladders and stairways, as necessary, which would enable each employee to recognize hazards related to ladders and stairways and train each employee in the procedures to be followed to minimize these hazards.  Marshall Road Worksite On or about July 9, 2015 the employer failed to adequately train employees to recognize hazards related to aluminum extension ladders used for trench access and egress.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

View N. Granese & Sons, INC's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 340768340.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.