Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: DANIEL CONSTRUCTION

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of DANIEL CONSTRUCTION in SANDSTONE AND 214TH STREETS, GRETNA, NE 68028 (NAICS 238130). OSHA activity number 341079812.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Daniel Construction — free Get an email when a new federal OSHA severe-injury report for Daniel Construction is published. One employer, no account, unsubscribe in one click.
Establishment
DANIEL CONSTRUCTION
Site address
SANDSTONE AND 214TH STREETS
City
GRETNA
State
NE
ZIP
68028
Mailing
6008 S. 40TH STREET, OMAHA, NE 68107
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
5
Ownership type
A

5 citations on file for this inspection.

1926.501 B13

Serious Gravity 10 1 instance 2 exposed
Issued
Nov 25, 2015
Abate by
Dec 24, 2015
Penalty
Initial $2,800 · Current $1,400 Reduced
29 CFR 1926.501(b)(13):     Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b):     Worksite located at Sandstone and 214th Streets, Gretna NE; a residential structure:  Employees were observed working on residential structure performing framing activities without any type of fall protection system in use.  This exposed the employees to falls in excess of 10 feet.        Abatement certification and abatement documentation is required for this violation.  The documentation should include written verification of abatement, applicable measurements or monitoring results, and photographs or videos which you believe will be helpful.  The abatement certification sheet is enclosed with the citations.
Recent events (2)
  • — I (S) $1400
  • — Z (S) $2800

1926.503 A01

Serious Gravity 5 1 instance 4 exposed
Issued
Nov 25, 2015
Abate by
Dec 24, 2015
Penalty
Initial $2,000 · Current $1,000 Reduced
29 CFR 1926.503(a)(1):     The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:     Jobsite located at Sandstone and 214th Streets and Throughout the Company:  The employer failed to train employees that were potentially exposed to fall hazards to enable each employee to recognize the hazards associated with the type of work being conducted.  This should include training on mitigating those hazards through an acceptable method of fall protection.  Training should also include the requirements for fall protection systems and when it is appropriate to utilize those systems.         Abatement certification is required for this violation.  The abatement certification sheet is enclosed with the citations.
Recent events (2)
  • — I (S) $1000
  • — Z (S) $2000

1926.1053 A08

Serious Gravity 5 1 instance 1 exposed
Issued
Nov 25, 2015
Penalty
Initial $1,600 · Current $800 Reduced
29 CFR 1926.1053(a)(8):     A metal spreader or locking device was not provided on each stepladder to hold the front and back sections in an open position when the ladder was being used:      Worksite located at Sandstone and 214th Streets, Gretna NE:  A 6 foot-self supporting ladder did not have the metal spreader or locking device engaged.  The ladder was leaned against the wall so that employees could access the upper roof surface.
Recent events (2)
  • — I (S) $800
  • — Z (S) $1600

1926.1053 B13

Serious Gravity 5 1 instance 1 exposed
Issued
Nov 25, 2015
Penalty
Initial $1,600 · Current $800 Reduced
29 CFR 1926.1053(b)(13):     The top or top step of a stepladder was used as a step:    Worksite located at Sandstone and 214th Streets, Gretna NE; a residential structure:  An employee was observed using the top step of an 8 foot self-supporting ladder to access the top of a metal beam.
Recent events (2)
  • — I (S) $800
  • — Z (S) $1600

1926.1060 A

Serious Gravity 5 1 instance 4 exposed
Issued
Nov 25, 2015
Abate by
Dec 24, 2015
Penalty
Initial $1,600 · Current $800 Reduced
29 CFR 1926.1060(a):     The employer did not provide a training program for each employee using ladders and stairways, as necessary, which would enable each employee to recognize hazards related to ladders and stairways and train each employee in the procedures to be followed to minimize these hazards.       Throughout the Company:  Employees had not been trained on the proper use of portable ladders.         Abatement certification is required for this violation.  The abatement certification sheet is enclosed with the citations.
Recent events (2)
  • — I (S) $800
  • — Z (S) $1600

View Daniel Construction's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 341079812.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.