Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: SUTHERLANDS

Complaint inspection · Safety discipline

On , OSHA opened a complaint safety inspection of SUTHERLANDS in 2101 E. AUSTIN, NEVADA, MO 64772 (NAICS 444110). OSHA activity number 341273753.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Sutherlands — free Get an email when a new federal OSHA severe-injury report for Sutherlands is published. One employer, no account, unsubscribe in one click.
Establishment
SUTHERLANDS
Site address
2101 E. AUSTIN
City
NEVADA
State
MO
ZIP
64772
Mailing
2101 E. AUSTIN, NEVADA, MO 64772
Inspection type
Complaint (B)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
444110
Employees
20
Ownership type
A

4 citations on file for this inspection.

5(a)(1)

Serious Gravity 10 1 instance 4 exposed
Issued
Apr 28, 2016
Abate by
Jun 2, 2016
Penalty
Initial $2,800 · Current $1,960 Reduced
Section 5(a)(1) of the Occupational Safety & Health Act of 1970:  The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to a fall hazard:  a) Lumber Department:  Employees were exposed to fall hazards as they had been standing on the forks of the forklift 6 or more feet above the floor to put up stock or to get stock down from the racks.  Among other methods, one feasible and acceptable means of abatement would be as follows:  1) Utilize only platforms designed for use in elevating personnel with forklifts.  These platforms must meet the requirements set forth in ANSI/ITSDF B56.1-2012 Safety Standard for Low Lift and High Lift Trucks Section 4.17 Elevating Personnel, and 7.37 Platforms: Elevating Platforms for elevating personnel shall have (a) a slip resistant floor surface, (b) a minimum floor space of 450 mm X 450 mm for each platform occupant. (c) protection for personnel in their normal working position on the platform from moving parts of the truck that represent a hazard. (d) restraining means such as a guard rail or a means for securing personnel such as a body belt or lanyard whenever the platform can be elevated to a height greater than 1 200 mm.  2) Utilize a stand up forklift with a harness and lanyard to access the racking.
Recent events (2)
  • — I (S) $1960
  • — Z (S) $2800

1910.26 C02 VII

Serious Gravity 5 2 instances 5 exposed
Issued
Apr 28, 2016
Abate by
Jun 2, 2016
Penalty
Initial $1,600 · Current $1,120 Reduced
29 CFR 1910.26(c)(2)(vii): 1910.26(c)(2)(7): Ladders having defects were not marked and taken out of service until repaired.  (a) Lawn and Garden: Employees were exposed to fall hazards as the Blue Louisville Steel Warehouse Rolling 10 foot Ladder in Lawn and Garden had a bent right front foot and a bent frame and was not taken out of service.   (b) Outdoor Lawn and Garden: The 6 foot Yellow Davidson Pro Ladder the spreaders were loose the tray was detached, and the Silver 6 foot Davidson Ladder the bottom step was damaged. Both Davidson Pro ladders were located in Outdoor Lawn and Garden, and they were not taken out of service.
Recent events (2)
  • — I (S) $1120
  • — Z (S) $1600

1910.178 L04 I

Deleted Serious Gravity 5 2 instances 7 exposed
Issued
Apr 28, 2016
Abate by
Jun 2, 2016
Penalty
Initial $1,600 · Current $0 Reduced
29 CFR 1910.178(l)(4)(i): Refresher training, including an evaluation of the effectiveness of that training, shall be conducted as required by paragraph (l)(4)(ii) to ensure that the operator has the knowledge and skills needed to operate the powered industrial truck safely.  (a)  Forklift operators were not given refresher training when employees had been lifting other employees on the forks of the forklift, and the backrest of the Hyster 80 forklift was damaged.
Recent events (2)
  • — I (S) $0
  • — Z (S) $1600

1910.178 P01

Serious Gravity 5 1 instance 7 exposed
Issued
Apr 28, 2016
Abate by
Jun 2, 2016
Penalty
Initial $1,600 · Current $1,120 Reduced
29 CFR 1910.178(p)(1): Powered industrial truck(s) found to be in need of repair, defective, or in any way unsafe had not been  taken out of service until restored to safe operating condition(s):  (a) Lumber:  Employees were exposed to struck by hazards as the Hyster 80 propane forklift had a bent load backrest with 2 uprights missing and the forklift had not been taken out of service until it was in safe operating condition.
Recent events (2)
  • — I (S) $1120
  • — Z (S) $1600

View Sutherlands's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 341273753.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.