OSHA Inspection: VICKS LITHOGRAPH & PRINTING CORP.

Issued

Jul 1, 2016

Abate by

Jul 14, 2016

Penalty

Initial $2,975 · Current $1,785 Reduced

General-duty citation text

29 CFR 1910.22(a)(1): All places of employment, passageways, storerooms or service rooms were not kept clean and orderly or in a sanitary condition:    a)  Shredder/Baler Room, on or about 6/15/16:  There was an accumulation of paper dust around the auto tie baler on the floors, horizontal surfaces and electrical equipment.    Abatement certification must be submitted for this item.

Issued

Jul 1, 2016

Abate by

Aug 6, 2016

Penalty

Initial $2,380 · Current $1,428 Reduced

General-duty citation text

29 CFR 1910.23(c)(1): Open-sided floors and/or platforms four feet or more above adjacent floor or ground level were not guarded with standard railings (or equivalent):    a)  M200 Web Press Room, on or about 6/15/16:  Platform on the web press, approximately 6 feet from floor level was not guarded at the right side next to the web.    Abatement certification must be submitted for this item.

Issued

Jul 1, 2016

Abate by

Aug 6, 2016

Penalty

Initial $2,975 · Current $1,785 Reduced

General-duty citation text

29 CFR 1910.212(a)(1): One or more methods of machine guarding was not provided to protect the operator and other employees in the machine area from hazards such as those created by point of operation, ingoing nip points, rotating parts, flying chips and sparks:    a)  IST Dept., on or about 6/15/16:  Ingoing nip points on the conveyor belts and pulley drives to the shrink wrap oven were not guarded.    b)  M200 Room, on or about 6/15/16:  Ingoing nip points on the M200 web press conveyor to stacker were not guarded.    Abatement certification must be submitted for these items.

Issued

Jul 1, 2016

Abate by

Aug 6, 2016

Penalty

Initial $2,380 · Current $1,428 Reduced

General-duty citation text

29 CFR 1910.219(c)(2): All exposed parts of horizontal shafting seven (7) feet or less from floor or working platform, excepting runways used exclusively for oiling, or running adjustments, were not protected by a stationary casing enclosing shafting completely:    a)  IST Dept., on or about 6/15/16:  Rotating shaft with keyway driving the conveyor to the shrink wrap oven was not adequately guarded.    Abatement certification must be submitted for this item.

Issued

Jul 1, 2016

Abate by

Aug 6, 2016

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.219(h)(1): Projecting key(s), setscrew(s), or other projections in revolving part(s) were not removed, made flush, or guarded by metal cover(s):  a)  IST Dept., on or about 6/15/16:  Rotating shaft end with setscrews driving the conveyor to the shrink wrap oven was not guarded.  Abatement certification must be submitted for this item.