Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: RAUSCH COLEMAN HOMES

Unprogrammed Other inspection · Safety discipline

On , OSHA opened an unprogrammed Other safety inspection of RAUSCH COLEMAN HOMES in PLATEAU DR, CONWAY, AR 72032 (NAICS 236115). OSHA activity number 341781672.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Rausch Coleman Homes — free Get an email when a new federal OSHA severe-injury report for Rausch Coleman Homes is published. One employer, no account, unsubscribe in one click.
Site address
PLATEAU DR
City
CONWAY
State
AR
ZIP
72032
Mailing
271 NEWMAN DR, NORTH LITTLE ROCK, AR 72117
Inspection type
Unprogrammed Other (I)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
236115
Employees
138
Ownership type
A

2 citations on file for this inspection.

1926.501 B13

Serious Gravity 10 3 instances 6 exposed
Issued
Jan 19, 2017
Abate by
Feb 2, 2017
Penalty
Initial $11,408 · Current $5,704 Reduced
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b):    a. On or about September 14 and 15, 2016 at a worksite located at or near 2845 Plateau Dr, Conway, AR 72032, the general contractor did not ensure that the framing subcontractor protected employees from fall hazards while working on a roof top that was approximately 25ft above lower levels.  b. On or about September 15, 2016 at a worksite located at or near 2810 Plateau Dr, Conway, AR 72032, the general contractor did not ensure that the guttering subcontractor protected employees from fall hazards while installing gutters on a roof edge that was approximately 15 feet above lower levels.  c. On or about September 15, 2016 at a worksite located at or near 2740 Plateau Dr, Conway, AR 72032, the general contractor did not ensure that the siding subcontractor protected employees from fall hazards while installing sidings on a roof edge that was approximately 13 feet above lower levels.
Recent events (2)
  • — I (S) $5704
  • — Z (S) $11408

1926.1053 B01

Serious Gravity 10 3 instances 6 exposed
Issued
Jan 19, 2017
Abate by
Jan 30, 2017
Penalty
Initial $11,408 · Current $5,704 Reduced
29 CFR 1926.1053(b)(1): Where (a) portable ladder(s) was/were used for access to an upper level landing surface and the ladder's length did not allow the ladder side rails to extend at least 3 feet (0.9 m) above the upper landing surface being accessed, the ladder was not secured at its top to a rigid support that will not deflect, and/or a grasping device was not provided to assist employees in mounting and dismounting the ladder.    a. On or about September 14, 2016 at a worksite located at or near 2845 Plateau Dr, Conway, AR 72032, the general contractor did not prevent subcontract employees sheathing the roof of a residential building from being exposed to fall from height hazards when mounting and dismounting a ladder that was not extended at least 3 feet above the upper landing surface.  b. On or about September 15, 2016 at a residential construction worksite located at or near 2810 Plateau Dr, Conway, AR 72032, the general contractor did not prevent subcontract employees from being exposed to fall from height hazards when ascending and descending to and from a roof on a stepladder that was not extended at least 3 feet above the upper landing surface.  c. On or about September 15, 2016 at a worksite located at or near 2740 Plateau Dr, Conway, AR 72032, the general contractor did not ensure that the subcontractor did not expose employees to fall from height hazards when mounting and dismounting a ladder that was not extended at least 3 feet above the upper landing surface.
Recent events (2)
  • — I (S) $5704
  • — Z (S) $11408

View Rausch Coleman Homes's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 341781672.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.