OSHA Inspection: STORK'S MOWER SHOP LLC

Issued

2017-02-10 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.212(a)(5): Fan blade guards, where the periphery of the blades was less than seven feet above the floor or working level, had openings larger than one half inch:  Shop Area, north side, the squirrel cage blower fan mounted onto a cart, did not have guards for the fan blades.

Issued

2017-02-10 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.219(e)(3)(i): Vertical or inclined belt(s) were not enclosed by guard(s) conforming to the requirements specified at 29 CFR 1910.219(m) and (o):  Shop area, north side, on the cart mounted squirrel cage fan, the belt drive was missing its guard.

Issued

2017-02-10 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.304(b)(3)(i): All 125-volt, single-phase, 15- and 20-ampere receptacles installed in wet locations were not equipped with ground-fault circuit-interrupter protection for personnel:  In the Restroom, the 110 volt electrical receptacle was not the GFCI type.

Issued

2017-02-10 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.305(a)(2)(ix): Lamps for general illumination were not protected from accidental contact or breakage by a suitable fixture or lamp holder with a guard:  Throughout the Shop Area, the bulbs in the 17 fluorescent light assemblies were not protected from breakage by the use of assembly covers or bulb sleeves.

Issued

2017-02-10 00:00:00

Abate by

2017-03-09 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.305(g)(1)(iv)(A): Flexible cords and/or cables were used as a substitute for the fixed wiring of a structure:  Shop Area, west wall to the outside shed area, a 110 volt extension cord was used to supply power to the outside area.

Issued

2017-02-10 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.334(a)(2)(ii): There was a defect or evidence of damage that could have exposes an employee to injury and the defective or damaged item was not removed from service:  In the Shop area, on the Windermere pedestal fan, the cover over the inner electrical wiring was missing.

Issued

2017-02-10 00:00:00

Abate by

2017-03-09 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.141(d)(2)(ii): Lavatories were not provided with hot and cold, or tepid running water:  The water supply to the restroom was only cold water.

Issued

2017-02-10 00:00:00

Abate by

2017-03-09 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.1200(e)(1): The employer did not develop, implement, and/or maintain at the workplace a written hazard communication program which describes how the criteria specified in 29 CFR 1910.1200(f), (g), and (h) will be met:  A written Hazard Communications program had not been developed to inform and train employees to protect them from chemical hazards while working with but not limited to motor oil, penetrating oil, and gasket maker.

Issued

2017-02-10 00:00:00

Abate by

2017-03-09 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.1200(g)(1): The employer did not have a safety data sheet for each hazardous chemical in use:  The employer did not have safety data sheets for the hazardous chemicals such as, but not limited to motor oil, penetrating oil and gasket maker.

Issued

2017-02-10 00:00:00

Abate by

2017-03-09 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.1200(h)(2)(i): The employer did not provide information to the employees on the requirements of the Hazard Communication Standard 29 CFR 1910.1200:  Employees had not been trained regarding the use of hazardous chemicals such as but not limited to various motor oils, penetrating oil and gasket maker.