OSHA Inspection: JESKEY, LLC

Issued

Mar 17, 2017

Abate by

May 3, 2017

Penalty

Initial $3,622 · Current $2,535 Reduced

General-duty citation text

29 CFR 1910.147(c)(1): Energy control program. The employer shall establish a program consisting of energy control procedures, employee training and periodic inspections to ensure that before any employee performs any servicing or maintenance on a machine or equipment where the unexpected energizing, startup or release of stored energy could occur and cause injury, the machine or equipment shall be isolated from the energy source and rendered inoperative.  WORKSHOP:   The employer had not established and implemented a site specific hazardous energy control lockout/tagout program consisting of machine specific step-by-step written energy control procedures and employee training for the employees during servicing and maintenance of equipment, such as (but not limited to) the CNC lathes and milling machines.

Issued

Mar 17, 2017

Abate by

May 3, 2017

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.147(c)(4)(i): Procedures shall be developed, documented and utilized for the control of potentially hazardous energy when employees are engaged in the activities covered by this section.   WORKSHOP:  The employer had not established and implemented written step-by-step energy control procedures in the machine specific for the employees during servicing and maintenance of equipment, such as (but not limited to) the CNC lathes and milling machines.

Issued

Mar 17, 2017

Abate by

May 3, 2017

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.147(c)(7)(i): The employer shall provide training to ensure that the purpose and function of the energy control program are understood by employees and that the knowledge and skills required for the safe application, usage, and removal of the energy controls are acquired by employees.   WORKSHOP:  The employees, as authorized, affected and/or other types were not provided with training and information in the controlling of potentially hazardous and unexpected releases of energy sources (lockout/tagout) during servicing and maintenance of equipment, such as (but not limited to) the CNC lathe and milling machines.

Issued

Mar 17, 2017

Abate by

May 3, 2017

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1910.132(d)(2): The employer shall verify that the required workplace hazard assessment has been performed through a written certification that identifies the workplace evaluated; the person certifying that the evaluation has been performed; the date(s) of the hazard assessment; and, which identifies the document as a certification of hazard assessment.  WORKSHOP:  The employer had not verified through a written certification that the workplace hazard assessment for personal protective equipment (PPE) had been performed as complete.