Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: FALCON FRAMERS, LLC

Complaint inspection · Safety discipline

On , OSHA opened a complaint safety inspection of FALCON FRAMERS, LLC in 1421 PROMONTORY ROAD, BOISE, ID 83702 (NAICS 238130). OSHA activity number 342285509.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Falcon Framers, LLC — free Get an email when a new federal OSHA severe-injury report for Falcon Framers, LLC is published. One employer, no account, unsubscribe in one click.
Establishment
FALCON FRAMERS, LLC
Site address
1421 PROMONTORY ROAD
City
BOISE
State
ID
ZIP
83702
Mailing
2280 NORTH MAPLE GROVE ROAD, BOISE, ID 83704
Inspection type
Complaint (B)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
5
Ownership type
A

4 citations on file for this inspection.

1926.502 D06 I

Serious Gravity 10 1 instance 2 exposed
Issued
May 24, 2017
Abate by
May 31, 2017
Penalty
Initial $3,803 · Current $3,500 Reduced
29 CFR 1926.502(d)(6)(i): When a snaphook is not a locking type and not designed for the following connections, snaphooks were engaged directly to webbing, rope or wire rope:    a) North/south side of roof: On or about April 27, 2017 and at times prior thereto an employee performing framing activities improperly used components of a fall protection system.  A lanyard and snaphook were wrapped around a wooden truss and then hooked directly back on to the rope lanyard. This was used as the anchor point for the employee's personal fall protection.      b) North/south side of roof: On or about April 27, 2017 and at times prior an employee performing framing activities   improperly used components of a fall protection system.  A snaphook and retractable cloth lanyard were wrapped around a wooden truss and then hooked directly back on to the cloth lanyard. This was used as the anchor point for the employee's personal fall protection.      Note) Certification and documentation of corrective action ARE required for this item.
Recent events (3)
  • — F (S) $3500
  • — C (S) $3803
  • — Z (S) $3803

1926.502 D15 II

Serious Gravity 10 1 instance 2 exposed
Issued
May 24, 2017
Abate by
Jun 6, 2017
Penalty
Initial $0 · Current $0
29 CFR 1926.502(d)(15)(ii): Anchorages used for attachment of personal fall arrest equipment were not installed, and used under the supervision of a qualified person:  a) North and south side of main roof: On or about April 27, 2017 and at times prior thereto components of the personal fall protection system were not used in accordance with the manufacturers instructions.  A snaphook was attached directly to a shock absorbing rope lanyard.    b)  North and south side of main roof: On or about April 27, 2017 and at times prior thereto components of the personal fall protection system were not used in accordance with the manufacturers instructions.  A snaphook was attached directly to a Miller Scorpion shock absorbing retractable cloth lanyard.    Note) Certification and documentation ARE required for this item.
Recent events (3)
  • — F (S) $0
  • — C (S) $0
  • — Z (S) $0

1926.503 A02 III

Serious Gravity 10 1 instance 4 exposed
Issued
May 24, 2017
Abate by
Jun 6, 2017
Penalty
Initial $0 · Current $0
29 CFR 1926.503(a)(2)(iii): The employer did not assure that each employee had been trained, as necessary, by a competent person qualified in the use and operation of guardrail systems, personal fall arrest systems, safety net systems, warning line systems, safety monitoring systems, controlled access zones, and other protection to be used:  a) Jobsite: On or about April 27, 2017 and at times prior thereto employees performing framing activities did not recognize the hazard of working on a flat roof deck without a guardrail system in place.  The employees did not take any action to minimize or eliminate the hazard.      b) Jobsite: On or about April 27, 2017 and at times prior thereto employees performing framing activities did not recognize the improper use of components as part of their fall protection system.  Snaphooks attached directly to shock absorbing rope lanyards were used as anchor points.  The employees did not take any action to correct the hazard.    Note) Certification and documentation of corrective action are required for this item.
Recent events (3)
  • — F (S) $0
  • — C (S) $0
  • — Z (S) $0

1926.501 B13

Repeat Gravity 10 1 instance 4 exposed
Issued
May 24, 2017
Abate by
May 31, 2017
Penalty
Initial $7,605 · Current $3,500 Reduced
29 CFR 1926.501(b)(13): Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels was not protected by guardrail systems, safety net system, or personal fall arrest system:    a) Jobsite: On April 27, 2017 and at times prior thereto employees performed sheathing activities on a 10 in 12 pitched roof without a fall protection system in place. Employees were exposed to a 22 foot fall hazard from eave to ground.      b) Jobsite: On April 27, 2017 and at times prior thereto employees performed framing activities on a flat roof deck.  A guardrail or other fall protection system was not in place. Employees were exposed to a 16 foot fall hazard from the roof deck to the concrete and ground below.      c) Jobsite: On April 27, 2017 and at times prior thereto employees performed framing activities on the second floor near window openings.  A guardrail across the opening or another fall protection system was not in place.  Employees were exposed to a 16 foot fall hazard to the ground below.    Note) Certification and documentation are required for this item.    Falcon Framers, LLC was previously cited for a violation of this occupational safety standard, 29CFR 1926.501(b)(13), which was contained in OSHA inspection number 962580, citation number 1, item number 1, and was affirmed as a final order on May 30, 2014, with respect to a workplace located at 963 West Laughton Drive, Meridian, ID 83642.
Recent events (3)
  • — F (R) $3500
  • — C (R) $7605
  • — Z (R) $7605

View Falcon Framers, LLC's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 342285509.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.