Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: 4 M CONSTRUCTION

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of 4 M CONSTRUCTION in FM 1255 @ FM 17, CANTON, TX 75103 (NAICS 237110). OSHA activity number 342696622.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch 4 M Construction — free Get an email when a new federal OSHA severe-injury report for 4 M Construction is published. One employer, no account, unsubscribe in one click.
Establishment
4 M CONSTRUCTION
Site address
FM 1255 @ FM 17
City
CANTON
State
TX
ZIP
75103
Mailing
P.O. BOX 100, POYNOR, TX 75782
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
237110
Employees
4
Ownership type
A

3 citations on file for this inspection.

1926.651 K01

Serious Gravity 10 1 instance 2 exposed
Issued
Oct 19, 2017
Abate by
Dec 15, 2017
Penalty
Initial $5,577 · Current $2,000 Reduced
29 CFR 1926.651(k)(1): The employer did not ensure that daily inspections of excavations, the adjacent areas, and protective systems shall be made by a competent person for evidence of a situation that could result in possible cave-ins, indications of failure of protective systems, hazardous atmospheres, or other hazardous conditions. An inspection shall be conducted by the competent person prior to the start of work and as needed throughout the shift. Inspections shall also be made after every rainstorm or other hazard increasing occurrence. These inspections are only required when employee exposure can be reasonably anticipated.    On or about October 11, 2017, employees were exposed to cave-in hazards while working in an excavation that measured approximately 6 feet in depth, 4 feet wide and approximately 28 feet long.  The spoil pile was not kept at least 2 feet back from the vertical walls.
Recent events (2)
  • — I (S) $2000
  • — Z (S) $5577

1926.651 J02

Repeat Gravity 10 1 instance 2 exposed
Issued
Oct 19, 2017
Abate by
Dec 15, 2017
Penalty
Initial $10,140 · Current $0 Reduced
29 CFR 1926.651(j)(2): Employees were not protected from excavated or other materials or equipment that could pose a hazard by falling or rolling into excavations. Protection was not provided by placing and keeping such materials or equipment at least 2 feet (.61 m) from the edge of excavations, or by the use of retaining devices that are sufficient to prevent materials or equipment from falling or rolling into excavations, or by a combination of both if necessary:    Employees were exposed to struck-by hazards while working in an excavation where debris was not kept at least 2-feet back from the edge.29 CFR 1926.652(a)(1): Each employee in an excavation was not protected from cave-ins by an adequate protective system designed in accordance with paragraph (b) or (c) of this section:    4 M Construction was previously cited for a violation of this occupational safety and health standard or its equivalent standard which was contained in OSHA inspection number 1079302, citation number 1, item number 1b and was affirmed as a final order on August 25, 2015, with respect to a workplace located at 708 E. College Street, Athens, Texas.
Recent events (2)
  • — I (R) $0
  • — Z (R) $10140

1926.652 A01

Repeat Gravity 10 1 instance 2 exposed
Issued
Oct 19, 2017
Abate by
Dec 15, 2017
Penalty
Initial $27,885 · Current $20,000 Reduced
29 CFR 1926.652(a)(1): Each employee in an excavation was not protected from cave-ins by an adequate protective system designed in accordance with paragraph (b) or (c) of this section:    Employees were exposed to cave-in hazards while working in an excavation when entering and exiting a trench approximately 6-feet deep.      4 M Construction was previously cited for a repeat violation of this occupational safety and health standard or its equivalent standard which was contained in OSHA inspection number 1160985, citation number 2, item number 1 and was affirmed as a final order on August 25, 2016, with respect to a workplace located at the 6700 Block of Broadway, Tyler, Texas.
Recent events (2)
  • — I (R) $20000
  • — Z (R) $27885

View 4 M Construction's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 342696622.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.