Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: UPSTATE FRAMING INC.

Unprogrammed Other inspection · Safety discipline

On , OSHA opened an unprogrammed Other safety inspection of UPSTATE FRAMING INC. in 700 MAIN ST., PEEKSKILL, NY 10566 (NAICS 238130). OSHA activity number 342906096.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Upstate Framing INC. — free Get an email when a new federal OSHA severe-injury report for Upstate Framing INC. is published. One employer, no account, unsubscribe in one click.
Site address
700 MAIN ST.
City
PEEKSKILL
State
NY
ZIP
10566
Mailing
144 RTE. 59 STE. 1, SUFFERN, NY 10901
Inspection type
Unprogrammed Other (I)
Scope
Complete (A)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
12
Ownership type
A

4 citations on file for this inspection.

1926.503 A01

Other-than-serious 3 instances 3 exposed
Issued
Mar 30, 2018
Abate by
Sep 20, 2018
Penalty
Initial $7,114 · Current $1,000 Reduced
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards:    Location: entire site  On or about: 12/21/17    a) Employees, exposed to fall hazards while engaged in carpentry work, were not provided with fall protection training.       NOTE: The employer is required to submit abatement certification for this item in accordance with 29 CFR 1903.19.
Recent events (3)
  • — J (O) $1000
  • — C (S) $7114
  • — Z (S) $7114

1926.1060 A

Other-than-serious 3 instances 3 exposed
Issued
Mar 30, 2018
Abate by
Sep 20, 2018
Penalty
Initial $0 · Current $0
29 CFR 1926.1060(a): The employer did not provide a training program for each employee using ladders and stairways, as necessary:    location: entire site  on or about: 12/21/17      a) Employees were using a wooden job made ladder to access the second level.  The employees were not provided with ladder safety training.       NOTE: The employer is required to submit abatement certification for this item in accordance with 29 CFR 1903.19.
Recent events (3)
  • — J (O) $0
  • — C (S) $0
  • — Z (S) $0

1926.1053 B01

Serious Gravity 1 1 instance 7 exposed
Issued
Mar 30, 2018
Penalty
Initial $4,268 · Current $1,940 Reduced
29 CFR 1926.1053(b)(1): When portable ladders were used for access to an upper landing surface, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder was not secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail,  was not provided to assist employees in mounting and dismounting the ladder:      location: exterior building between ground and 2nd floor  on or about: 12/21/17      a) Employees were using an job made wooden ladder to access the 2nd floor. The ladder only extended above the upper level approximately 1 foot.       NOTE: Because abatement of this violation is already documented in the inspection casefile, the employer need not submit certification or documentation of abatement for this violation as normally required by 29 CFR 1903.19.
Recent events (3)
  • — J (S) $1940
  • — C (S) $4268
  • — Z (S) $4268

1926.501 B01

Repeat Gravity 10 1 instance 7 exposed
Issued
Mar 30, 2018
Penalty
Initial $19,918 · Current $9,060 Reduced
29 CFR 1926.501(b)(1): Each employee on a walking/working surface with an unprotected side or edge which was 6 feet (1.8 m) or more above a lower level was not protected from falling by the use of guardrail systems, safety net systems, or personal fall arrest systems:    location: 2nd floor  on or about: 12/21/17    a) Employees were engaged in carpentry work, 11 feet above the ground. The employees were not protected from falling to the ground and floor below.        NOTE: Because abatement of this violation is already documented in the inspection case file, the employer need not submit certification or documentation of abatement for this violation as normally required by 29 CFR 1903.19.    The Upstate Framing Inc. was previously cited for a violation of this occupational safety and health standard or its equivalent standard 1926.501(b)(13), which was contained in OSHA inspection number 960943, citation number 1, item number 5 and was affirmed as a final order on 5/14/2014, with respect to a workplace located at 115 Winterton Road, Bloomingburg, NY 12721.
Recent events (3)
  • — J (R) $9060
  • — C (R) $19918
  • — Z (R) $19918

View Upstate Framing INC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 342906096.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.