SEMMES, AL —
OSHA Inspection: JUAN ROJAS
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of JUAN ROJAS in 1304 FAIRLAWN DRIVE LOTT#339, SEMMES, AL 36575 (NAICS 238130). OSHA activity number 342980018.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- JUAN ROJAS
- Site address
- 1304 FAIRLAWN DRIVE LOTT#339
- City
- SEMMES
- State
- AL
- ZIP
- 36575
- Mailing
- 4661 JOHN SIMS ROAD, WILMER, AL 36587
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- Employees
- 25
- Ownership type
- A
Citations
4 citations on file for this inspection.
1926.501 B13
- Issued
- May 17, 2018
- Penalty
- Initial $5,691 · Current $3,410 Reduced
General-duty citation text
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b): a) 1304 Fairlawn Drive (Lott#339) Semmes, Alabama: On or about February 27, 2018, and at times prior; the employer allowed and observed his employee(s) performing framing activities wearing full body harnesses without connecting to an anchor point and by improperly connecting lanyards/ropes to the front of full body harnesses, exposing them to a fall hazard of up to approximately eighteen (18) feet to the concrete floor or ground below.
Recent events (2)
- — I (S) $3410
- — Z (S) $5691
1926.502 D09
- Issued
- May 17, 2018
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.502(d)(9): Lanyards and/or vertical lifelines did not have a minimum breaking strength of 5,000 pounds (22.2 kN): a) 1304 Fairlawn Drive (Lott#339) Semmes, Alabama: On or about February 27, 2018, and at times prior; the employer allowed and observed his employee(s) performing framing activities with lanyards improperly connected to the life line by simple knot instead of a metal approved connector; exposing them to fall hazards of up to approximately eighteen (18) feet to the concrete floor or ground below.
Recent events (2)
- — I (S) $0
- — Z (S) $0
1926.502 D17
- Issued
- May 17, 2018
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.502(d)(17): The attachment point of the body harness was not located in the center of the wearer's back near shoulder level, or above the wearer's head: a) 1304 Fairlawn Drive (Lott#339) Semmes, Alabama: On or about February 27, 2018, and at times prior; the employer allowed and observed his employee(s) performing framing activities wearing full body harnesses improperly connected; in that the lanyard/rope was tied to the front of the body harnesses, exposing them to fall hazards of up to approximately eighteen (18) feet to the concrete floor or ground below.
Recent events (2)
- — I (S) $0
- — Z (S) $0
1926.503 A01
- Issued
- May 17, 2018
- Abate by
- May 30, 2018
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards: a) 1304 Fairlawn Drive (Lott#339) Semmes, Alabama: On or about February 27, 2018, and at times prior; the employer failed to ensure and/or provide fall protection training to his employees. Exposed employees performing framing activities wearing full body harnesses improperly connected and improperly anchored themselves to the structure by nailing the anchor rope into the wood without an anchor plate type device; exposing them to fall hazards of up to approximately eighteen (18) feet to the concrete floor or ground below.
Recent events (2)
- — I (S) $0
- — Z (S) $0
More inspections at Juan Rojas
View Juan Rojas's full OSHA safety record →
More inspections in this industry (NAICS 238130)
More inspections in AL
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 342980018.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.