WEST MONROE, LA —
OSHA Inspection: EASON PORTABLE BUILDINGS
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of EASON PORTABLE BUILDINGS in 1304 NATCHITOCHES STREET, WEST MONROE, LA 71291 (NAICS 332999). OSHA activity number 343038501.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- EASON PORTABLE BUILDINGS
- Site address
- 1304 NATCHITOCHES STREET
- City
- WEST MONROE
- State
- LA
- ZIP
- 71291
- Mailing
- 1304 NATCHITOCHES STREET, WEST MONROE, LA 71291
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 332999
- Employees
- 17
- Ownership type
- A
Citations
6 citations on file for this inspection.
5(a)(1)
- Issued
- May 1, 2018
- Abate by
- May 18, 2018
- Penalty
- Initial $3,326 · Current $1,996 Reduced
General-duty citation text
OSH ACT of 1970 Section (5)(a)(1): The employer did not furnish employment and a place of employment which was free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that they were exposed to crushing and struck-by hazards. On or about 3/22/18 in the production shop; the employer allowed employees, and the employees were observed operating the Nissan 30 powered industrial fork truck without wearing the seat belts provided as a restraint device; thus exposing employees to serious injuries in the event of a tip-over.
Recent events (2)
- — I (S) $1995.6
- — Z (S) $3326
1910.28 B01 I
- Issued
- May 1, 2018
- Abate by
- May 18, 2018
- Penalty
- Initial $2,661 · Current $1,597 Reduced
General-duty citation text
29 CFR 1910.28(b)(1)(i): The employer did not ensure that each employee on a walking-working surface with an unprotected side or edge that is 4 feet (1.2m) or more above a lower level was protected from falling by guardrail systems, safety net system, or personal fall arrest system: On or about 3/22/18 on the mezzanine in the south end of the Production shop; employer allowed employees to store materials 8.5' above the production floor with 16' of missing guardrail at the edge of the mezzanine floor.
Recent events (2)
- — I (S) $1596.6
- — Z (S) $2661
1910.178 L01 II
- Issued
- May 1, 2018
- Abate by
- May 18, 2018
- Penalty
- Initial $2,661 · Current $1,597 Reduced
General-duty citation text
29 CFR 1910.178(l)(1)(ii): The employer did not ensure that each operator had successfully completed the training required by paragraph (l), except as permitted by paragraph (l)(5), prior to permitting an employee to operate a powered industrial truck: On or about 3/22/18 in the production shop; the employer allowed employees, and the employees were observed operating the Nissan 30 powered industrial fork truck without having successfully completed the training required by paragraph (l).
Recent events (2)
- — I (S) $1596.6
- — Z (S) $2661
1910.219 D01
- Issued
- May 1, 2018
- Penalty
- Initial $2,827 · Current $1,696 Reduced
General-duty citation text
29 CFR 1910.219(d)(1): Pulley(s) with part(s) seven feet or less from the floor or work platform were not guarded in accordance with the requirements specified in 29 CFR 1910.219(m) and (o): On or about 3/22/18 in the Framing Department; the employer allowed employees to work near and around the Ingersoll-Rand air compressor (#CBV135251) without a guard over the pulleys.
Recent events (2)
- — I (S) $1696.2
- — Z (S) $2827
1910.219 E03 I
- Issued
- May 1, 2018
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.219(e)(3)(i): Vertical or inclined belt(s) were not enclosed by guard(s) conforming to the requirements specified at 29 CFR 1910.219(m) and (o)(a): On or about 3/22/18 in the Framing Department; the employer allowed employees to work near and around the Ingersoll-Rand air compressor (#CBV135251) without a guard over the belts.
Recent events (2)
- — I (S) $0
- — Z (S) $0
1910.22 B
- Issued
- May 1, 2018
- Abate by
- May 18, 2018
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.22(b): (b) Loads. The employer must ensure that each walking-working surface can support the maximum intended load for that surface. On or about 3/22/18 on the mezzanine in the south end of the Production shop; employer allowed employees to store materials on the mezzanine floor and the floor did not have a posted load limit.
Recent events (2)
- — I (O) $0
- — Z (O) $0
More inspections at Eason Portable Buildings
View Eason Portable Buildings's full OSHA safety record →
More inspections in this industry (NAICS 332999)
More inspections in LA
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343038501.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.