OSHA Inspection: PEDRO JUAREZ

Issued

Sep 21, 2018

Abate by

Oct 5, 2018

Penalty

Initial $2,217 · Current $2,217

General-duty citation text

29 CFR 1926.102(a)(1): The employer did not ensure that each affected employee used appropriate eye or face protection when exposed to eye or face hazards from flying particles.  On or about September 17, 2018 at the above addressed jobsite, an employee was using a pneumatic nail gun and was not wearing safety glasses, thereby exposing the employee to hazards associated with eye injuries.  Abatement certification is required for this item in accordance with the requirements of 29 CFR 1903.19(c).

Issued

Sep 21, 2018

Abate by

Oct 5, 2018

Penalty

Initial $3,880 · Current $3,880

General-duty citation text

29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b):  On or about September 17, 2018 at the above addressed jobsite, employees were performing roofing operations approximately 10.9-17.2 feet above ground and were not using fall protection, thereby exposing employees to fall hazards.  Abatement documentation is required for this item in accordance with the requirements of 29 CFR 1903.19(d).

Issued

Sep 21, 2018

Abate by

Oct 5, 2018

Penalty

Initial $2,217 · Current $2,217

General-duty citation text

29 CFR 1926.1053(b)(1): Where portable ladders were used for access to an upper landing surface and the ladder's length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed:  On or about September 17, 2018 at the above addressed jobsite, the portable ladder used to access the roof did not extend at least three (3') feet above the upper landing surface, thereby exposing employees to hazards associated with falls.  Abatement certification is required for this item in accordance with the requirements of 29 CFR 1903.19(c).