OSHA Inspection: JP ROOFING, INC.

Issued

Oct 17, 2018

Abate by

Nov 13, 2018

Penalty

Initial $2,217 · Current $1,109 Reduced

General-duty citation text

29 CFR 1926.501(b)(10): Each employee engaged in roofing activities on low-slope roofs with unprotected sides and edges 6 feet or more above lower levels, was not protected from falling by guardrail systems, safety net systems, personal fall arrest systems, or a combination of warning line system and guardrail systems, warning line system and personal fall arrest system, or warning line system and safety monitoring system:       (a)JP Roofing, Inc. @ 6601 W. 41st Street, Sioux Falls, SD 57106: On or about and at times prior to October 3, 2016, the exposing employer did not ensure that employees involved in re-roofing activities on a garage at the Regency Place Apartments, working on a 4 in 12 pitched roof, were protected from falling by guardrail systems, safety net systems, or personal fall arrest systems. The condition exposed employee to a 8-foot fall hazard.

Issued

Oct 17, 2018

Abate by

Nov 13, 2018

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards.    (a)JP Roofing, Inc. @ 6601 W. 41st Street, Sioux Falls, SD 57106: On or about and at times prior to October 3, 2016, the exposing employer did not ensure that each employee engaged in roofing operations were trained to recognize the hazards of working at elevation and trained in the use of fall protection. Employees engaged in roofing activities worked near the edge of a one-story, a 4 in 12 pitch roof without the use of a fall protection system. This condition exposed employees to a fall of approximately 8 feet.     Abatement Note: The employer shall assure that each employee has been trained, as necessary, by a competent person qualified in the following areas:     a)      The nature of fall hazards in the work area;  b)      The correct procedures for erecting, maintaining, disassembling, and inspecting the fall protection systems to be used;  c)      The use and operation of guardrail systems, personal fall arrest systems, safety net systems, warning line systems, safety monitoring systems, controlled access zones, and other protection to be used;  d)     The role of each employee in the safety monitoring system when this system is used;  e)      The limitations on the use of mechanical equipment during the performance of roofing work on low-sloped roofs;  f)       The correct procedures for the handling and storage of equipment and materials and the erection of overhead protection; and  g)      The role of employees in fall protection plans;  h)      The standards contained in this subpart.     Abatement Note: 1926.503(b)(1) provides that the employer shall verify compliance with paragraph (a) of this section by preparing a written certification record. The written certification record shall contain the name or other identity of the employee trained, the date(s) of the training, and the signature of the person who conducted the training or the signature of the employer. If the employer relies on training conducted by another employer or completed prior to the effective date of this section, the certification record shall indicate the date the employer determined the prior training was adequate rather than the date of actual training.

Issued

Oct 17, 2018

Abate by

Nov 13, 2018

Penalty

Initial $0 · Current $0

General-duty citation text

29 CFR 1926.1053(b)(1): A portable ladder was used for access to an upper landing, and the ladder side rails did not extend at least 3 feet above the upper landing, and was not secured:     (a)JP Roofing, Inc. @ 6601 W. 41st Street, Sioux Falls, SD 57106: On or about and at times prior to October 3, 2016, the exposing employer did not ensure that a portable extension ladder, used to access the roof of a garage, had side rails extending 3 feet above the upper landing, and was secured. This condition exposed three employees to fall hazards of approximately 8 feet.