OSHA Inspection: STK ELECTRONICS, INC.

Issued

2019-09-18 00:00:00

Penalty

Initial $4508.00 · Current $2705.00 Reduced

General-duty citation text

:29 CFR 1910.212(a)(1): One or more methods of machine guarding was not provided to protect the operator and other employees in the machine area from hazards such as those created point of operation, rotating parts, and flying chips:    a)  Flex Con Assembly, on or about 4/25/19: Two Craftsman Drill Presses were not provided with a chuck and tool guard.    b) Flex Con Assembly, on or about 4/25/19:  Action Drill Press, model WTC-10 was not provided with a chuck and tool guard.    c) Flex Con Assembly, on or about 4/25/19:  Delta Drill Press was not provided with a chuck and tool guard.    d) Maintenance Room, on or about 4/25/19: Jet Mill was not provided with a chuck and tool guard.     e) Maintenance Room, on or about 4/25/19: Chicago Drill Press was not provided with a chuck and tool guard.

Issued

2019-09-18 00:00:00

Penalty

Initial $3381.00 · Current $2029.00 Reduced

General-duty citation text

29 CFR 1910.242(b): Compressed air used for cleaning purposes was not reduced to less than 30 p.s.i.:    a) Maintenance Room, on or about 4/25/19: Employee used compressed air for cleaning purposes was measured at approximately 63 p.s.i.

Issued

2019-09-18 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.304(g)(5): The path to ground from circuits, equipment, and enclosures was not permanent, continuous and effective:   a)  Flex Con Area, on or about 4/25/19: Metal Desk Lamp was not grounded in that it had only a two wire cord.