Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: JUAN FLOREZ

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of JUAN FLOREZ in 275 BEAR, WAXAHACHIE, TX 75165 (NAICS 238350). OSHA activity number 344418611.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Juan Florez — free Get an email when a new federal OSHA severe-injury report for Juan Florez is published. One employer, no account, unsubscribe in one click.
Establishment
JUAN FLOREZ
Site address
275 BEAR
City
WAXAHACHIE
State
TX
ZIP
75165
Mailing
7219 MARINGO DR., DALLAS, TX 75227
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238350
Employees
6
Ownership type
A

6 citations on file for this inspection.

1926.102 A01

Serious Gravity 1 1 instance 6 exposed
Issued
Dec 2, 2019
Abate by
Dec 31, 2019
Penalty
Initial $1,705 · Current $1,705
29 CFR 1926.102(a)(1): Employees were not provided with eye and face protection equipment when machines or operations presented potential eye or face injury from physical, chemical, or radiation agents.   On the east side of the construction site, employees engaged in decking work used pneumatic nail guns and were not wearing eye and face protection.  The employees were exposed to struck-by hazards and eye injuries.
Recent events (1)
  • — Z (S) $1705

1926.304 D

Serious Gravity 5 1 instance 6 exposed
Issued
Dec 2, 2019
Abate by
Dec 31, 2019
Penalty
Initial $2,273 · Current $2,273
29 CFR 1926.304(d): Each portable, power-driven circular saw withdrawn from the work did not automatically and instantly return the lower guard to the covering position of the saw.   On the east side of the construction site, employees operating a Makita skill saw with the lower guard wedged in the up position while cutting decking material were exposed to amputation hazards.
Recent events (1)
  • — Z (S) $2273

1926.501 B13

Serious Gravity 5 1 instance 6 exposed
Issued
Dec 2, 2019
Abate by
Dec 31, 2019
Penalty
Initial $2,842 · Current $2,842
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b).     On the east side of the construction site, employees engaged in decking work without fall protection, were exposed to fall hazards of approximately 9-feet to the ground below.
Recent events (1)
  • — Z (S) $2842

1926.1051 A

Serious Gravity 5 1 instance 6 exposed
Issued
Dec 2, 2019
Abate by
Dec 31, 2019
Penalty
Initial $2,273 · Current $2,273
29 CFR 1926.1051(a): Stairway(s) or ladder(s) were not provided at all personnel points of access where there was a break in elevation of 19 inches (48 cm) or more, or no ramp, runway, sloped embankment, or personnel hoist was provided.     On the east side of the construction site, the employer did not provide an extension ladder where employees could access and egress the building's upper landings, exposing employees to potential fall hazards.
Recent events (1)
  • — Z (S) $2273

1926.503 A01

Other-than-serious 1 instance 6 exposed
Issued
Dec 2, 2019
Abate by
Dec 31, 2019
Penalty
Initial $319 · Current $319
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:   On the east side of the construction site, employees engaged in decking work were without fall protection, and the employer did not provide a training program nor training on the recognition and avoidance of falls.
Recent events (1)
  • — Z (O) $319

1926.1060 A

Other-than-serious 1 instance 6 exposed
Issued
Dec 2, 2019
Abate by
Dec 31, 2019
Penalty
Initial $319 · Current $319
29 CFR 1926.1060(a): The employer did not provide a training program for each employee using ladders and stairways, that enabled each employee to recognize hazards related to ladders and stairways, and that trained each employee in the procedures to be followed to minimize those hazards:  On the east side of the construction site, the employer did not provide a ladder training program and did not provide hazard recognition and proper ladder usage and access training.  Employees were exposed to potential fall hazards.
Recent events (1)
  • — Z (O) $319

View Juan Florez's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 344418611.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.