Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: JESUS GARCIA

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of JESUS GARCIA in 438 PATINA DRIVE, MONTGOMERY, TX 77316 (NAICS 238130). OSHA activity number 345367304.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Jesus Garcia — free Get an email when a new federal OSHA severe-injury report for Jesus Garcia is published. One employer, no account, unsubscribe in one click.
Establishment
JESUS GARCIA
Site address
438 PATINA DRIVE
City
MONTGOMERY
State
TX
ZIP
77316
Mailing
1415 SHADOW MOUNTAIN DR., KATY, TX 77450
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Last modified
Data loaded
NAICS code
238130
Employees
8
Ownership type
A

8 citations on file for this inspection.

1926.102 A01

Serious Gravity 5 2 instances 2 exposed
Issued
Jul 26, 2021
Abate by
Aug 12, 2021
Penalty
Initial $2,926 · Current $2,926
29 CFR  1926.102(a)(1):The employer shall ensure that each affected employee uses appropriate eye or face protection when exposed to eye or face hazards from flying particles, molten metal, liquid chemicals, acids or caustic liquids, chemical gases or vapors, or potentially injurious light radiation.  On or about June 11, 2021, at 438 Patina Drive in Montgomery, TX, two employees were exposed to an injury while operating nail guns without wearing eye protection.
Recent events (1)
  • — Z (S) $2926

1926.451 B03

Serious Gravity 5 1 instance 1 exposed
Issued
Jul 26, 2021
Abate by
Aug 12, 2021
Penalty
Initial $2,926 · Current $2,926
29 CFR  1926.451(b)(3):Except as provided in paragraphs (b)(3)(i) and (ii) of this section, the front edge of all platforms shall not be more than 14 inches (36 cm) from the face of the work, unless guardrail systems are erected along the front edge and/or personal fall arrest systems are used in accordance with paragraph (g) of this section to protect employees from falling.  On or about June 11, 2021, at 438 Patina Drive in Montgomery, TX, an employee was exposed to a fall hazard while working on a pump jack scaffold whose front edge was more than 14 inches (36 cm) from the face of the work.
Recent events (1)
  • — Z (S) $2926

1926.451 C02

Serious Gravity 10 1 instance 1 exposed
Issued
Jul 26, 2021
Abate by
Aug 12, 2021
Penalty
Initial $0 · Current $0
29 CFR  1926.451(c)(2):Supported scaffold poles, legs, posts, frames, and uprights shall bear on base plates and mud sills or other adequate firm foundation.  On or about June 11, 2021, at 438 Patina Drive in Montgomery, TX, an employee was exposed to a fall hazard while working from a pump jack scaffold that did not have an adequate foundation on base plates and mud sills that would prevent the scaffold from settling into the ground.
Recent events (1)
  • — Z (S) $0

1926.451 F03

Serious Gravity 5 1 instance 1 exposed
Issued
Jul 26, 2021
Abate by
Aug 12, 2021
Penalty
Initial $0 · Current $0
29 CFR  1926.451(f)(3): Scaffolds and scaffold components shall be inspected for visible defects by a competent person before each work shift, and after any occurrence which could affect a scaffold's structural integrity.   On or about June 11, 2021, at 438 Patina Drive in Montgomery, TX, employees were building a cornice from a pump jack scaffold without the scaffold being inspected by a competent person.
Recent events (1)
  • — Z (S) $0

1926.451 G01 VII

Serious Gravity 10 2 instances 2 exposed
Issued
Jul 26, 2021
Abate by
Aug 12, 2021
Penalty
Initial $0 · Current $0
29 CFR  1926.451(g)(1)(vii): For all scaffolds not otherwise specified in paragraphs (g)(1)(i) through (g)(1)(vi) of this section, each employee shall be protected by the use of personal fall arrest systems or guardrail systems meeting the requirements of paragraph (g)(4) of this section.   On or about June 11, 2021, at 438 Patina Drive in Montgomery, TX, two employees were exposed to fall hazards of more than 10 feet while building cornice: a.	An employee was working from a pump jack scaffold at about 13 ft. high. b.	An employee was working from a job-made wooden scaffold at about 20 ft. high.
Recent events (1)
  • — Z (S) $0

1926.452 J02

Serious Gravity 5 1 instance 1 exposed
Issued
Jul 26, 2021
Abate by
Aug 12, 2021
Penalty
Initial $0 · Current $0
29 CFR  1926.452(j)(2):Poles shall be secured to the structure by rigid triangular bracing or equivalent at the bottom, top, and other points as necessary. When the pump jack has to pass bracing already installed, an additional brace shall be installed approximately 4 feet (1.2 m) above the brace to be passed, and shall be left in place until the pump jack has been moved and the original brace reinstalled.  On or about June 11, 2021, at 438 Patina Drive in Montgomery, TX, an employee was exposed to  fall hazard while working from a pump jack scaffold that was not secured by rigid bracing.
Recent events (1)
  • — Z (S) $0

1926.454 A

Serious Gravity 1 2 instances 2 exposed
Issued
Jul 26, 2021
Abate by
Aug 12, 2021
Penalty
Initial $1,755 · Current $1,755
29 CFR  1926.454(a):The employer shall have each employee who performs work while on a scaffold trained by a person qualified in the subject matter to recognize the hazards associated with the type of scaffold being used and to understand the procedures to control or minimize those hazards.  On or about June 11, 2021, at 438 Patina Drive in Montgomery, TX, two employees were exposed to fall hazards of more than 10 feet while building cornice: a.	An employee was working from a pump jack scaffold without training on the use and hazards associated with scaffolding systems. b.	An employee was working from a job-made wooden scaffold at about 20 ft. high without training on the use and hazards associated with scaffolding systems.
Recent events (1)
  • — Z (S) $1755

1926.503 A01

Serious Gravity 1 2 instances 2 exposed
Issued
Jul 26, 2021
Abate by
Aug 12, 2021
Penalty
Initial $0 · Current $0
29 CFR  1926.503(a)(1): The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards.  On or about June 11, 2021, at 438 Patina Drive in Montgomery, TX, two employees were exposed to fall hazards of more than 10 feet while building cornice: a.	An employee was working from a pump jack scaffold without training on the use and hazards associated with scaffolding systems. b.	An employee was working from a job-made wooden scaffold at about 20 ft. high without training on the use and hazards associated with scaffolding systems.
Recent events (1)
  • — Z (S) $0

View Jesus Garcia's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 345367304.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.