Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: AMZ MANUFACTURING CORPORATION

Complaint inspection · Safety discipline

On , OSHA opened a complaint safety inspection of AMZ MANUFACTURING CORPORATION in 2206 PENNSYLVANIA AVENUE, YORK, PA 17404 (NAICS 332813). OSHA activity number 345582886.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch AMZ Manufacturing Corporation — free Get an email when a new federal OSHA severe-injury report for AMZ Manufacturing Corporation is published. One employer, no account, unsubscribe in one click.
Site address
2206 PENNSYLVANIA AVENUE
City
YORK
State
PA
ZIP
17404
Mailing
2206 PENNSYLVANIA AVENUE, YORK, PA 17404
Inspection type
Complaint (B)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
332813
Employees
50
Ownership type
A

4 citations on file for this inspection.

1910.22 C

Serious Gravity 5 1 instance 2 exposed
Issued
Jan 28, 2022
Abate by
Jun 1, 2022
Penalty
Initial $7,925 · Current $14,000
29 CFR  1910.22(c):(c) Access and egress.  The employer must provide, and ensure each employee uses, a safe means of access and egress to and from walking-working surfaces:  (a)  BACK WAREHOUSE, TANK AREA - Employees used the top step and the cap of a Werner eight foot step ladder to access the top of the salt tank and then manually climbed approximately 36 inches to an adjacent tank which was 11 feet high without any additional equipment to facilitate safe access to the tanks, on or about October 13, 2021.  Abatement certification required within 10 days after abatement date.  The certification shall include a statement that abatement is complete, date and method of abatement, and states employees and their representatives were informed of this abatement.
Recent events (2)
  • — I (S) $14000
  • — Z (S) $7925

1910.23 C08

Serious Gravity 5 1 instance 1 exposed
Issued
Jan 28, 2022
Abate by
Jun 1, 2022
Penalty
Initial $0 · Current $0
29 CFR 1910.23(c)(8): The employer did not ensure that the cap (if equipped) and top step of a stepladder that were not used as steps:  (a)  BACK WAREHOUSE, SALTS TANK - Employees used the top step and the cap of a Werner eight foot step ladder to access the top of the salt tank when servicing the tank equipment, on or about October 13, 2021.  Abatement certification required within 10 days after abatement date.  The certification shall include a statement that abatement is complete, date and method of abatement, and states employees and their representatives were informed of this abatement.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1910.28 B01 I

Serious Gravity 5 1 instance 2 exposed
Issued
Jan 28, 2022
Abate by
Jun 1, 2022
Penalty
Initial $7,925 · Current $0 Reduced
29 CFR 1910.28(b)(1)(i):  Except as provided elsewhere in this section 29 CFR 1910.28, the employer did not ensure that each employee on a walking-working surface with an unprotected side or edge that is 4 feet (1.2 m) or more above a lower level was protected from falling by one or more of the systems described in 29 CFR 1910.28(b)(1)(i):  (a)  BACK WAREHOUSE, TOPS OF CHEMICAL HOLDING TANKS - Employees walked across and worked from the tops of the salt tank, the re-use water tank, and the evaporator salts tank when servicing the tank equipment and the employer had not ensured that the employees were protected from falling , on or about October 13, 2021.  Abatement certification required within 10 days after abatement date.  The certification shall include a statement that abatement is complete, date and method of abatement, and states employees and their representatives were informed of this abatement.
Recent events (2)
  • — I (S) $0
  • — Z (S) $7925

1910.132 F01 IV

Other-than-serious Gravity 5 1 instance 50 exposed
Issued
Jan 28, 2022
Abate by
Jun 1, 2022
Penalty
Initial $7,925 · Current $0 Reduced
1910.132(f)(1)(iv):  Employee(s) required to use PPE by this section were not trained to know the limitations of PPE:   (a)  PRODUCTION AREA - Employees performed electroplating operations where the work involved placing parts into and removing parts from tanks that were filled with chemicals that included strong acids with PH ratings less than 6 and strong alkalines with PH ratings of greater than 12.    The employer did not require and enforce the use of personal protective required by safety data sheets for the chemicals that were being used which included safety goggles and/or face shields, on or about October 13, 2021.  Abatement certification required within 10 days after abatement date.  The certification shall include a statement that abatement is complete, date and method of abatement, and states employees and their representatives were informed of this abatement.
Recent events (2)
  • — I (O) $0
  • — Z (S) $7925

View AMZ Manufacturing Corporation's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 345582886.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.