FLAT ROCK, NC —
OSHA Inspection: U.S. DEPT. OF INTERIOR
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of U.S. DEPT. OF INTERIOR in 1800 LITTLE RIVER ROAD, FLAT ROCK, NC 28731 (NAICS 928110). OSHA activity number 346509169.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- U.S. DEPT. OF INTERIOR
- Site address
- 1800 LITTLE RIVER ROAD
- City
- FLAT ROCK
- State
- NC
- ZIP
- 28731
- Mailing
- 1800 LITTLE RIVER ROAD, FLAT ROCK, NC 28731
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- A
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 928110
- Employees
- 12
- Ownership type
- D
Citations
7 citations on file for this inspection.
1910.22 B
- Issued
- Feb 27, 2023
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.22(b):(b) Loads. The employer must ensure that each walking-working surface can support the maximum intended load for that surface. Employees did not know the intended load limit for the mezzanine level, which was being used for storage.
Recent events (1)
- — Z (S) $0
1910.37 B02
- Issued
- Feb 27, 2023
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.37(b)(2):Each exit must be clearly visible and marked by a sign reading "Exit." Exit doors were not clearly marked exposing employees to entrapment and fire hazards in the event of a fire.
Recent events (1)
- — Z (S) $0
1910.215 B09
- Issued
- Feb 27, 2023
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.215(b)(9): 29 CFR 1910.215(b)(9): The distance between the abrasive wheel periphery(s) and the adjustable tongue or the end of the safety guard peripheral member at the top exceeded one fourth inch. Employees were exposed to a struck by hazard while working with a Delta 8 inch bench grinder that was missing a guard on its left side.
Recent events (1)
- — Z (S) $0
1910.303 B08 I
- Issued
- Feb 27, 2023
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.303(b)(8)(i):Electric equipment shall be firmly secured to the surface on which it is mounted. Note to paragraph (b)(8)(i) of this section: Wooden plugs driven into holes in masonry, concrete, plaster, or similar materials are not considered secure means of fastening electric equipment. Employer did not ensure multiple 208v electrical panel were firmly secured.
Recent events (1)
- — Z (S) $0
1910.304 G05
- Issued
- Feb 27, 2023
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.304(g)(5):Grounding path. The path to ground from circuits, equipment, and enclosures shall be permanent, continuous, and effective. The path to ground for a 25ft. extension cord was missing the ground pin and was not permanent, continuous and effective.
Recent events (1)
- — Z (S) $0
1910.305 B01 I
- Issued
- Feb 27, 2023
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.305(b)(1)(i):Conductors entering cutout boxes, cabinets, or fittings shall be protected from abrasion, and openings through which conductors enter shall be effectively closed. A junction box used to service lights and other equipment, was missing a knockout plug.
Recent events (1)
- — Z (S) $0
1910.1200 F06
- Issued
- Feb 27, 2023
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.1200(f)(6):Workplace labeling. Except as provided in paragraphs (f)(7) and (f)(8) of this section, the employer shall ensure that each container of hazardous chemicals in the workplace is labeled, tagged or marked with either: Employer did not ensure the spray bottle was properly labeled.
Recent events (1)
- — Z (S) $0
More inspections at U.S. Dept. of Interior
View U.S. Dept. of Interior's full OSHA safety record →
More inspections in this industry (NAICS 928110)
More inspections in NC
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 346509169.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.