Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: JMV CORNICE CONSTRUCTION, LLC

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of JMV CORNICE CONSTRUCTION, LLC in 3335 MONARCH PASS, ARLINGTON, TX 76005 (NAICS 238130). OSHA activity number 346624414.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch JMV Cornice Construction, LLC — free Get an email when a new federal OSHA severe-injury report for JMV Cornice Construction, LLC is published. One employer, no account, unsubscribe in one click.
Site address
3335 MONARCH PASS
City
ARLINGTON
State
TX
ZIP
76005
Mailing
621 COLLEGE ST., GRAND PRAIRIE, TX 75050
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
5
Ownership type
A

5 citations on file for this inspection.

1926.451 G01

Serious Gravity 5 3 instances 3 exposed
Issued
Apr 11, 2023
Penalty
Initial $2,846 · Current $1,708 Reduced
29 CFR  1926.451(g)(1):Employees on scaffolds more than 10 feet (3.1 m) above a lower level were not protected from falling to that lower level by fall protection established in paragraphs (g)(1)(i)-(vii) of this section:  On April 11, 2023, employee(s) worked from jack scaffolds without fall protection systems while installing cornice material on the exterior of a residential home.  The employee(s) were exposed to a fall hazard of approximately 15 feet to the ground below.  a)  Employee working on the west side of the home from a jack scaffold without fall protection, b)  Employee working on the south side of the home from a jack scaffold without fall protection, d)  Employee working on the east side of the home from a jack scaffold without fall protection.
Recent events (2)
  • — I (S) $1707.6
  • — Z (S) $2846

1926.1053 B01

Serious Gravity 1 3 instances 3 exposed
Issued
Apr 11, 2023
Penalty
Initial $1,707 · Current $1,024 Reduced
29 CFR  1926.1053(b)(1): Where portable ladders were used for access to an upper landing surface and the ladder's length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed.   On April 11, 2023, employees using an extension ladder that did not have the side rails extended three feet over the upper landing surface were exposed to potential fall hazards greater than ten feet.
Recent events (2)
  • — I (S) $1024.2
  • — Z (S) $1707

1926.100 A

Other-than-serious 3 instances 3 exposed
Issued
Apr 11, 2023
Penalty
Initial $320 · Current $192 Reduced
29 CFR  1926.100(a): Employees working in areas where there was a possible danger of head injury from impact, or falling or flying objects, or from electrical shock and burns, were not protected by protective helmets:   On April 11, 2023, employees were not wearing hardhats while working below other employees above that were engaged in cornice work from a jack scaffold was exposed to struck-by falling hazards.
Recent events (2)
  • — I (O) $192
  • — Z (O) $320

1926.503 A01

Other-than-serious 3 instances 3 exposed
Issued
Apr 11, 2023
Abate by
May 9, 2023
Penalty
Initial $0 · Current $0
29 CFR  1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:   On April 11, 2023, employee(s) worked from jack scaffolds without fall protection systems and were not provided fall hazard recognition and avoidance training;  a)  Employee working on the west side of the home from a jack scaffold without fall protection, b)  Employee working on the south side of the home from a jack scaffold without fall protection, d)  Employee working on the east side of the home from a jack scaffold without fall protection.
Recent events (2)
  • — I (O) $0
  • — Z (O) $0

1926.1060 A

Other-than-serious 3 instances 3 exposed
Issued
Apr 11, 2023
Abate by
May 9, 2023
Penalty
Initial $0 · Current $0
29 CFR  1926.1060(a): The employer did not provide a training program for each employee using ladders and stairways, as necessary, which would enable each employee to recognize hazards related to ladders and stairways and train each employee in the procedures to be followed to minimize these hazards.(a) (LOCATION) (IDENTIFY SPECIFIC OPERATIONS(S) AND/OR CONDITIONS)Note:  29 CFR 1926.21(b)(2) may be cited as an additional violation to support this requirement.   29 CFR  1926.1053(b)(1): Where portable ladders were used for access to an upper landing surface and the ladder's length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed.   On April 11, 2023, employees using an extension ladder that did not have the side rails extended three feet over the upper landing surface were exposed to potential fall hazards greater than ten feet.
Recent events (2)
  • — I (O) $0
  • — Z (O) $0

View JMV Cornice Construction, LLC's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 346624414.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.