CURTICE, OH —
OSHA Inspection: OTTAWA PRODUCTS CO
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of OTTAWA PRODUCTS CO in 1602 NORTH CURTICE ROAD, CURTICE, OH 43412 (NAICS 332722). OSHA activity number 347841504.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- OTTAWA PRODUCTS CO
- Site address
- 1602 NORTH CURTICE ROAD
- City
- CURTICE
- State
- OH
- ZIP
- 43412
- Mailing
- 1602 NORTH CURTICE ROAD, CURTICE, OH 43412
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 332722
- Employees
- 25
- Ownership type
- A
Citations
2 citations on file for this inspection.
1910.147 C01
- Issued
- Jan 6, 2025
- Penalty
- Initial $4,702 · Current $2,000 Reduced
General-duty citation text
29 CFR 1910.147(c)(1):The employer did not establish a program consisting of an energy control procedure, employee training and periodic inspections to ensure that before any employee performed any servicing or maintenance on a machine or equipment where the unexpected energizing, startup or release of stored energy could occur and cause injury, the machine or equipment shall be isolated from the energy source and rendered inoperative: a) Ottawa Products Co located at 1602 North Curtice Road, Curtice, Ohio, 43412: On or about October 24, 2024, the employer failed to ensure an energy control program consisting of control procedures, employee training and periodic inspections were developed and performed. Employees tasked with performing service or maintenance activities such as, but not limited to, set up of Videx machines without the benefit of energy isolation, hazardous energy recognition training and employer evaluation, exposed employees to potential caught in hazards.
Recent events (2)
- — I (S) $2000
- — Z (S) $4702
1910.212 A03 II
- Issued
- Jan 6, 2025
- Penalty
- Initial $3,918 · Current $2,000 Reduced
General-duty citation text
29 CFR 1910.212(a)(3)(ii): Point(s) of operation of machinery were not guarded to prevent employee(s) from having any part of their body in the danger zone(s) during operating cycle(s): a) Ottawa Products Co located at 1602 North Curtice Road, Curtice, Ohio, 43412: On or about October 24, 2024, the employer failed to ensure that the point of operation was adequately guarded on the "cold saw" located in the production area, exposing employees to point of operation and amputation hazards.
Recent events (2)
- — I (S) $2000
- — Z (S) $3918
More inspections at Ottawa Products CO
View Ottawa Products CO's full OSHA safety record →
More inspections in this industry (NAICS 332722)
More inspections in OH
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 347841504.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.