Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: HIDALGO ROOFING CONSTRUCTION, LLC

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of HIDALGO ROOFING CONSTRUCTION, LLC in 4601 LINDEN AVENUE, DAYTON, OH 45432 (NAICS 238160). OSHA activity number 347868192.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Hidalgo Roofing Construction, LLC — free Get an email when a new federal OSHA severe-injury report for Hidalgo Roofing Construction, LLC is published. One employer, no account, unsubscribe in one click.
Site address
4601 LINDEN AVENUE
City
DAYTON
State
OH
ZIP
45432
Mailing
49 REDINGTON COURT, DAYTON, OH 45449
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Last modified
Data loaded
NAICS code
238160
Employees
4
Ownership type
A

3 citations on file for this inspection.

1926.501 B01

Serious Gravity 10 1 instance 3 exposed
Issued
Nov 21, 2024
Penalty
Initial $5,323 · Current $2,600 Reduced
29 CFR  1926.501(b)(1):"Unprotected sides and edges." Each employee on a walking/working surface (horizontal and vertical surface) with an unprotected side or edge which is 6 feet (1.8 m) or more above a lower level shall be protected from falling by the use of guardrail systems, safety net systems, or personal fall arrest systems.  a) On or about November 07, 2024, the employer failed to ensure that employees performing roofing activities on an work area with unprotected sides and edges were utilizing a fall protection system. As a result, employees were exposed to a fall height of at least 9'0" on a 4/12 pitch roof.
Recent events (2)
  • — I (S) $2600
  • — Z (S) $5323

1926.1053 B01

Serious Gravity 10 1 instance 3 exposed
Issued
Nov 21, 2024
Penalty
Initial $5,323 · Current $0 Reduced
29 CFR  1926.1053(b): Use. The following requirements apply to the use of all ladders, including job-made ladders, except as otherwise indicated:  (1) When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support.  a) On or about November 07, 2024, the employer failed to ensure that the ladders being utilized by employees performing roofing activities to access the roof was extended 3 feet above the upper landing surface. As a result, employees were exposed to fall heights of at least 10'4".
Recent events (2)
  • — I (S) $0
  • — Z (S) $5323

1926.503 A02

Deleted Serious Gravity 10 1 instance 3 exposed
Issued
Nov 21, 2024
Abate by
Jan 10, 2025
Penalty
Initial $5,323 · Current $0 Reduced
29 CFR  1926.503(a)(2): Training program. The employer shall assure that each employee has been trained, as necessary, by a competent person qualified in the following areas: (i) The nature of fall hazards in the work area; (ii) The correct procedures for erecting, maintaining, disassembling, and inspecting the fall protection systems to be used; (iii) The use and operation of guardrail systems, personal fall arrest systems, safety net systems, warning line systems, safety monitoring systems, controlled access zones, and other protection to be used; (vi) The correct procedures for the handling and storage of equipment and materials and the erection of overhead protection; and (vii) The role of employees in fall protection plans; (viii) The standards contained in this subpart.  a) On or about November 07, 2024, the employer failed to ensure that employees performing roofing work were trained as necessary on the: nature of fall hazards in the work area, correct procedures for inspecting the fall protection being used, use and operation of personal fall arrest systems, and standards contained in this subpart.
Recent events (2)
  • — I (S) $0
  • — Z (S) $5323

View Hidalgo Roofing Construction, LLC's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 347868192.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.