Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: APPLETON LATHING CORPORATION

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of APPLETON LATHING CORPORATION in 5509 VERN HOLMES DR, STEVENS POINT, WI 54482 (NAICS 238130). OSHA activity number 347984924.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Appleton Lathing Corporation — free Get an email when a new federal OSHA severe-injury report for Appleton Lathing Corporation is published. One employer, no account, unsubscribe in one click.
Site address
5509 VERN HOLMES DR
City
STEVENS POINT
State
WI
ZIP
54482
Mailing
2300 AMERICAN DRIVE, NEENAH, WI 54956
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
A
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
145
Ownership type
A

4 citations on file for this inspection.

1926.451 A01

Serious Gravity 5 1 instance 2 exposed
Issued
Feb 14, 2025
Penalty
Initial $10,641 · Current $6,285 Reduced
29 CFR  1926.451(a)(1):  Scaffolds.  General requirements.  Except as provided in paragraphs (a)(2), (a)(3), (a)(4), (a)(5) and (g) of this section, each scaffold and scaffold component shall be capable of supporting, without failure, its own weight and at least 4 times the maximum intended load applied or transmitted to it.  On or about January 16, 2025, at 5509 Vern Holmes Drive in Stevens Point, Wisconsin, employees were exposed to a fall hazard while climbing up and walking on the inside edge of a scissor lift mid-guardrail to use the guardrail as a work platform.  The guardrail was not designed to be a walking working surface.
Recent events (2)
  • — I (S) $6284.6
  • — Z (S) $10641

1926.451 B02

Deleted Serious Gravity 5 1 instance 2 exposed
Issued
Feb 14, 2025
Penalty
Initial $0 · Current $0
29 CFR  1926.451(b)(2):  Scaffold platform construction.  Except as provided in paragraphs (b)(2)(i) and (b)(2)(ii) of this section, each scaffold platform and walkway shall be at least 18 inches (46 cm) wide.  On or about January 16, 2025, at 5509 Vern Holmes Drive in Stevens Point, Wisconsin, employees were exposed to a fall hazard working from a 0.5-inch wide, mid-rail of a scissor lift guardrail system that was not designed as a working surface.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.451 G01 VII

Deleted Serious Gravity 5 1 instance 2 exposed
Issued
Feb 14, 2025
Penalty
Initial $0 · Current $0
29 CFR  1926.451(g)(1)(vii):  Scaffolds.  Fall Protection.  Each employee on a scaffold more than 10 feet (3.1 m) above a lower level shall be protected from falling to that lower level. Paragraphs (g)(1)(i) through (vii) of this section establish the types of fall protection to be provided to the employees on each type of scaffold. For all scaffolds not otherwise specified in paragraphs (g)(1)(i) through (g)(1)(vi) of this section, each employee shall be protected by the use of personal fall arrest systems or guardrail systems meeting the requirements of paragraph (g)(4) of this section.  On or about January 16, 2025, at 5509 Vern Holmes Drive in Stevens Point, Wisconsin, employees were exposed to a fall hazard working from a scissor lift's mid-guardrail 10 ft. 4 in. above surface level without using required fall protection equipment.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.454 A03

Serious Gravity 5 1 instance 2 exposed
Issued
Feb 14, 2025
Abate by
Jun 2, 2025
Penalty
Initial $0 · Current $0
29 CFR  1926.454(a)(3):  The employer shall have each employee who performs work while on a scaffold trained by a person qualified in the subject matter to recognize the hazards associated with the type of scaffold being used and to understand the procedures to control or minimize those hazards. The training shall include the proper use of the scaffold, and the proper handling of materials on the scaffold.  On or about January 16, 2025, at 5509 Vern Holmes Drive in Stevens Point, Wisconsin, the employer did not provide required scaffold safety training for employees exposed to fall hazards while using a scissor lift.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

View Appleton Lathing Corporation's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 347984924.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.