FLOWERY BRANCH, GA —
OSHA Inspection: MARIO MENDEZ
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of MARIO MENDEZ in 5601 OVERVIEW DR LOT 116 MULBERRY SUMMIT, FLOWERY BRANCH, GA 30542 (NAICS 238170). OSHA activity number 348035031.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- MARIO MENDEZ
- Site address
- 5601 OVERVIEW DR LOT 116 MULBERRY SUMMIT
- City
- FLOWERY BRANCH
- State
- GA
- ZIP
- 30542
- Mailing
- 4797 GLENWHITE DR., DULUTH, GA 30096
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238170
- Employees
- 5
- Ownership type
- A
Citations
5 citations on file for this inspection.
1926.102 A01
- Issued
- Apr 14, 2025
- Penalty
- Initial $2,128 · Current $2,128
9013
General-duty citation text
29 CFR 1926.102(a)(1): Eye and face protective equipment were not used when machines or operations presented potential eye or face injury: a) New single-family residential structure located on Lot #116 at 5601 Overview Dr., Flowery Branch, GA 30542, Ground and scaffold: On or about 02/10/2025, the employer exposed employees to struck-by hazards while operating circular saws and pneumatic nail guns in that protective eyewear was not provided while cutting and installing siding material.
Recent events (1)
- — Z (S) $2128
1926.304 D
- Issued
- Apr 14, 2025
- Penalty
- Initial $4,256 · Current $4,256
General-duty citation text
29 CFR 1926.304(d): Portable, power-driven circular saw(s) were not equipped with a guard above and below the base plate or shoe: a) New single-family residential structure located at Lot #116 at 5601 Overview Dr., Flowery Branch, GA 30542, Ground level: On or about 2/10/2025, the employer exposed employees to amputation hazards while operating Makitia 5007F 7-1/4-inch circular saws, in that the lower guard did not retract immediately after a cut was made as a chock was used to keep the lower guard in the open position.
Recent events (1)
- — Z (S) $4256
1926.451 G01 VII
- Issued
- Apr 14, 2025
- Penalty
- Initial $2,837 · Current $2,837
General-duty citation text
29 CFR 1926.451(g)(1)(vii): Each employee on a scaffold, not otherwise specified in paragraphs (g)(1)(i) through (g)(1)(vi) of this section, more than 10 feet (3.1 m) above lower level was not protected from falls by the use of personal fall arrest systems or guardrail systems meeting the requirements of paragraph (g)(4) of this section. a) New single-family residential structure located at Lot #116 at 5601 Overview Dr., Flowery Branch, GA 30542, Scaffold Area: Employees were exposed to fall hazards of approximately 15 feet 6 inches to the lower ground below while utilizing a pump jack scaffolding system, in that a fall protection system was not available or utilized.
Recent events (1)
- — Z (S) $2837
1926.1153 C01
- Issued
- Apr 14, 2025
- Penalty
- Initial $3,547 · Current $3,547
9013
General-duty citation text
29 CFR 1926.1153(c)(1): For each employee engaged in a task identified on Table 1, the employer did not fully and properly implement the engineering controls, work practices, and respiratory protection specified for the task on Table 1, unless the employer assesses and limits the exposure of the employee to respirable crystalline silica in accordance with paragraph (d) of this section. a) New single-family residential structure located at Lot #116 at 5601 Overview Dr., Flowery Branch, GA 30542, Ground: On or about 02/10/2025, the employer exposed employees to respiratory hazards due to silica exposure from cutting cement fiber siding board, in that engineering controls, work practices, or respiratory protection as described in Table-1 were not adhered to.
Recent events (1)
- — Z (S) $3547
1926.1153 D02 I
- Issued
- Apr 14, 2025
- Penalty
- Initial $0 · Current $0
9013
General-duty citation text
29 CFR 1926.1153(d)(2)(i): The employer did not assess the exposure of each employee who was or may reasonably be expected to be exposed to respirable crystalline silica at or above the action level in accordance with either the performance option in paragraph (d)(2)(ii) or the scheduled monitoring option in paragraph (d)(2)(iii) of this section. a) New single-family residential structure located at Lot #116 at 5601 Overview Dr., Flowery Branch, GA 30542, Ground: On or about 10/22 /2024, the employer exposed employees to respiratory hazards in that the employer did not assess all employees who may be exposed to silica health hazards through monitoring to ensure they are not overexposed.
Recent events (1)
- — Z (S) $0
More inspections at Mario Mendez
View Mario Mendez's full OSHA safety record →
More inspections in this industry (NAICS 238170)
More inspections in GA
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 348035031.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.