Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: WEG ROOFING & CONSTRUCTION, LLC

Referral inspection · Safety discipline

On , OSHA opened a referral safety inspection of WEG ROOFING & CONSTRUCTION, LLC in 201 W. CENTRAL STREET, CHIPPEWA FALLS, WI 54729 (NAICS 238160). OSHA activity number 348266206.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch WEG Roofing & Construction, LLC — free Get an email when a new federal OSHA severe-injury report for WEG Roofing & Construction, LLC is published. One employer, no account, unsubscribe in one click.
Site address
201 W. CENTRAL STREET
City
CHIPPEWA FALLS
State
WI
ZIP
54729
Mailing
420 W WISCONSIN STREET, CHIPPEWA FALLS, WI 54729
Inspection type
Referral (C)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238160
Employees
7
Ownership type
A

6 citations on file for this inspection.

1926.501 B10

Serious Gravity 10 1 instance 2 exposed
Issued
Sep 19, 2025
Abate by
Oct 20, 2025
Penalty
Initial $3,972 · Current $1,986 Reduced
29 CFR  1926.501(b)(10): Each employee engaged in roofing activities on low-slope roofs with unprotected sides and edges 6 feet or more above lower levels, was not protected from falling by guardrail systems, safety net systems, personal fall arrest systems, or a combination of warning line system and guardrail system, warning line system and safety net system, or warning line system and personal fall arrest system, or warning line system and safety monitoring system; and/or on roofs 50-feet (15.25 m) or less in width, each employee was not protected by use of a monitoring system:  (a) Low-slope roof (RF-61 & RF-30) on west southwest side of building; On or about May 22, 2025, fall protection was not used while employees walked on, and stood directly at the edge of, a low-slope roof to dispose of shingles and underlayment materials that were removed during commercial reroofing operations.  The flat roof was approximately 54-feet, 10-inches long by 35-feet, 2-inches wide and ranged in height from 17-feet, 10-inches to 19-feet, 11-inches above the ground.
Recent events (2)
  • — I (S) $1986
  • — Z (S) $3972

1926.502 A02

Serious Gravity 10 1 instance 2 exposed
Issued
Sep 19, 2025
Abate by
Oct 20, 2025
Penalty
Initial $0 · Current $0
29 CFR 1926.502(a)(2): The employer did not provide and install all fall protection systems required by this subpart for an employee, and did not comply with all other pertinent requirements of this subpart before that employee began the work that necessitates the fall protection:  (a) Low-slope roof (RF-61 & RF-30) on west southwest side of building; On or about May 22, 2025, the employer did not ensure fall protection systems were provided and/or installed before employees walked on and stood directly at the edge of a low-slope roof to dispose of shingles and underlayment materials that were removed during commercial reroofing operations.  The flat roof was approximately 54-feet, 10-inches long by 35-feet, 2-inches wide and ranged in height from 17-feet, 10-inches to 19-feet, 11-inches above the ground.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.502 D

Serious Gravity 5 1 instance 2 exposed
Issued
Sep 19, 2025
Abate by
Oct 20, 2025
Penalty
Initial $2,270 · Current $1,135 Reduced
29 CFR 1926.502(d): The employer used body belts as part of a personal fall arrest system:  (a) Roof of church building; On or about May 22, 2025 and dates prior, roofing employees were permitted to use waist level attachment points at the front/side of body belts (climber style, hip-harnesses) as part of their personal fall arrest systems during reroofing operations of material tear off, roof preparation, and asphalt shingle installation.  The roof slopes varied from 2/12 to 17/12 and the eave height above the ground ranged from 14-feet, 8-inches to 19-feet, 11-inches.  Note: As of January 1, 1998, subpart M of this part (Sec. 1926.502(d)) provides that body belts are not acceptable as part of a personal fall arrest system.  The use of a body belt in a positioning device system for vertical surfaces, such as working on a wall, is regulated under Sec. 1926.502(e).
Recent events (2)
  • — I (S) $1135
  • — Z (S) $2270

1926.502 D17

Serious Gravity 5 1 instance 6 exposed
Issued
Sep 19, 2025
Abate by
Oct 20, 2025
Penalty
Initial $0 · Current $0
29 CFR 1926.502(d)(17): The attachment point of the body harness was not located in the center of the wearer's back near shoulder level, or above the wearer's head:   (a) Roof of church building; On or about May 22, 2025 and dates prior, the front/side connection point on climber style harnesses (hip-harness) were used as the attachment point for fall protection during reroofing operations of material tear off, roof preparation, and asphalt shingle installation.  The roof slopes varied from 2/12 to 17/12 and the eave height above the ground ranged from 14-feet, 8-inches to 19-feet, 11-inches.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1904.39 A02

Other-than-serious 1 instance 1 exposed
Issued
Sep 19, 2025
Penalty
Initial $2,838 · Current $1,419 Reduced
29 CFR 1904.39(a)(2):  The employer did not report within 24-hours a work-related incident resulting in in-patient hospitalization, amputation or the loss of an eye.  (a)	Throughout establishment; A work-related in-patient hospitalization that occurred on or about May 17, 2025 at 10:00am, was not reported to OSHA until May 19, 2025 at 2:30pm.
Recent events (2)
  • — I (O) $1419
  • — Z (O) $2838

1926.503 B01

Other-than-serious 1 instance 2 exposed
Issued
Sep 19, 2025
Abate by
Oct 20, 2025
Penalty
Initial $0 · Current $0
29 CFR 1926.503(b)(1): The employer did not verify compliance with paragraph (a) of this section by preparing a written (training) certification record including the name or other identity of the employee trained, the date(s) of the training, and the signature of the person who conducted the training or the signature of the employer:  (a) Throughout the establishment; On or about May 22, 2025 and dates prior, the employer did not develop or maintain a written certification of fall protection training for any of the workers onsite who were performing roofing operations on a roof with slopes that varied from 2/12 to 17/12 and were 14-feet, 8-inches to 19-feet, 11-inches above the lower level.
Recent events (2)
  • — I (O) $0
  • — Z (O) $0

View WEG Roofing & Construction, LLC's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 348266206.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.