LONGMONT, CO —
OSHA Inspection: XTREME COIL DRILLING CORPORATION
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of XTREME COIL DRILLING CORPORATION in RIG #11 WATERFRONT #1-3, LONGMONT, CO 80504 (NAICS 211111). OSHA activity number 311907083.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- XTREME COIL DRILLING CORPORATION
- Site address
- RIG #11 WATERFRONT #1-3
- City
- LONGMONT
- State
- CO
- ZIP
- 80504
- Mailing
- 139 WEST 2ND ST. #1B, CASPER, WY 82601
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 211111
- SIC code (legacy)
- 1311
- Employees
- 12
- Ownership type
- A
Citations
9 citations on file for this inspection.
5(a)(1)
- Issued
- Sep 30, 2008
- Abate by
- Oct 20, 2008
- Penalty
- Initial $1,875 · Current $1,875
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish a place of employment which was free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to struck by hazards: (a)Xtreme Coil Drilling Corporation at Rig #11 Waterfront #1-3, Longmont, CO 80504: On or before 8/25/08, the employer did not ensure the wire rope slip and cut practices were followed in accordance with the wire rope manufacturer's directions. The Union Wire Rope Cut-off Program provided that the employer was not to accumulate more than 1300 ton miles between cuts. The employer's ton mile log showed that the accumulated ton miles since the previous cut exceeded 1300 ton miles in the following instances: 1)On 4/13/08, 2,918 ton miles were recorded on the wire rope since the previous cut; and 2)On 6/6/08, 2,141 ton miles were recorded on the wire rope since the previous cut. In addition, the manufacturer provided that the employer was to keep the History Sheets current, accurate, and complete. However, the employer did not record and update the accumulated ton miles on the wire rope since May 23, 2008, three months prior to the OSHA inspection. Conditions exposed employees to struck by hazards if the wire rope was to part. Abatement Note: Abatement certification is required for this item (See enclosed "Sample Abatement-Certification Letter"). Among other methods, one feasible and acceptable abatement method is stated in API Recommended Practice 54, Section 9.6.6, which provides that, "When calculations indicate ton mile limits have been reached, or visual inspection shows breaks, crushing, or damage, the wire rope shall be slipped, cut, or replaced."
1910.132 D01
- Issued
- Sep 30, 2008
- Abate by
- Oct 20, 2008
- Penalty
- Initial $1,875
Recent events (2)
- — I (S)
- — Z (S) $1875.00
1910.132 D02
- Issued
- Sep 30, 2008
- Abate by
- Oct 20, 2008
Recent events (2)
- — I (S)
- — Z (S)
1910.146 D05 I
- Issued
- Sep 30, 2008
- Abate by
- Oct 20, 2008
- Penalty
- Initial $1,875 · Current $1,875
Recent events (2)
- — I (O) $1875.00
- — Z (S) $1875.00
1910.146 D05 II
- Issued
- Sep 30, 2008
- Abate by
- Oct 20, 2008
Recent events (2)
- — I (O)
- — Z (S)
1910.146 D06
- Issued
- Sep 30, 2008
- Abate by
- Oct 20, 2008
- Penalty
- Initial $1,875 · Current $1,125 Reduced
Recent events (2)
- — I (O) $1125.00
- — Z (S) $1875.00
1910.146 D09
- Issued
- Sep 30, 2008
- Abate by
- Oct 20, 2008
Recent events (2)
- — I (O)
- — Z (S)
1910.146 G01
- Issued
- Sep 30, 2008
- Abate by
- Oct 20, 2008
- Penalty
- Initial $1,875 · Current $1,125 Reduced
Recent events (2)
- — I (O) $1125.00
- — Z (S) $1875.00
1910.184 E01
- Issued
- Sep 30, 2008
- Abate by
- Oct 20, 2008
More inspections at Xtreme Coil Drilling Corporation
View Xtreme Coil Drilling Corporation's full OSHA safety record →
More inspections in this industry (NAICS 211111)
More inspections in CO
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 311907083.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.