Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: JAMES EVANS

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of JAMES EVANS in 220 HWY 6 WEST, BATESVILLE, MS 38606 (NAICS 238320). OSHA activity number 336134192.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch James Evans — free Get an email when a new federal OSHA severe-injury report for James Evans is published. One employer, no account, unsubscribe in one click.
Establishment
JAMES EVANS
Site address
220 HWY 6 WEST
City
BATESVILLE
State
MS
ZIP
38606
Mailing
1126 WILD CAT BOTTOM ROAD, RED BANKS, MS 38661
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238320
Employees
2
Ownership type
A

5 citations on file for this inspection.

1926.451 C02

Serious Gravity 1 1 instance 2 exposed
Issued
Sep 10, 2012
Penalty
Initial $1,200 · Current $1,200
29 CFR 1926.451(c)(2):     Supported scaffold poles, legs, posts, frames, and uprights did not bear on base plates and mud sills or other adequate firm foundation:    a) At 220 Hwy 6 West - On or about September 5, 2012, an , employees were working from a scaffold platform that was missing base plates and mud sills.
Recent events (1)
  • — Z (S) $1200

1926.451 G01 VII

Serious Gravity 5 1 instance 2 exposed
Issued
Sep 10, 2012
Penalty
Initial $2,000 · Current $2,000
29 CFR 1926.451(g)(1)(vii):     For all scaffolds not otherwise specified in paragraphs (g)(1)(i) through (g)(1)(vi) of this section, each employee shall be protected by the use of personal fall arrest systems or guardrail systems meeting the requirements of paragraph (g)(4) of this section.    a) At 220 Hwy 6 West - On or about September 5, 2012, employees were working from a scaffold platform that was 12 feet 9 inches above the parking lot without any fall protection such as a guardrail system.
Recent events (1)
  • — Z (S) $2000

1926.451 H02 II

Serious Gravity 1 1 instance 1 exposed
Issued
Sep 10, 2012
Penalty
Initial $0 · Current $0
29 CFR 1926.451(h)(2)(ii):     A toeboard was not erected along the edge of platforms more than 10 feet (3.1 m) above lower levels for a distance sufficient to protect employees below:    a) At 220 Hwy 6 West - On or about September 5, 2012, the scaffold platform was 12 feet 9 inches above the ground and did not have a toeboard around the platform.
Recent events (1)
  • — Z (S) $0

1926.452 C02

Serious Gravity 5 1 instance 2 exposed
Issued
Sep 10, 2012
Penalty
Initial $0 · Current $0
29 CFR 1926.452(c)(2):     Tubular welded frames and panels were not braced by cross, horizontal, or diagonal braces, or combination thereof, which would have secured vertical members together laterally:    a) At 220 Hwy 6 West - On or about September 5, 2012, employees were working from a scaffold platform that was 12 feet 9 inches above the parking lot without any cross braces on the side next to the building.
Recent events (1)
  • — Z (S) $0

1926.451 E06 VI

Serious Gravity 5 1 instance 2 exposed
Issued
Sep 10, 2012
Penalty
Initial $1,600 · Current $1,600
29 CFR 1926.451(e)(6)(vi):     29 CFR 1926.451(e)(6)(vi): Integral prefabricated scaffold access frames did not have a maximum spacing between rungs of 16 3/4 inches (43 cm). Non-uniform rung spacing caused by joining end frames together is allowed, provided the spacing does not exceed 16 3/4 inches (43 cm).    a) At 220 Hwy 6 West - On or about September 5, 2012, employees were climbing on the support ends of the scaffold to access the platform. The distance between the horizontal members ranged from 18.5 to 19 inches.
Recent events (1)
  • — Z (S) $1600

View James Evans's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 336134192.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.