GETTYSBURG, PA —
OSHA Inspection: HILLANDALE GETTYSBURG LP
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of HILLANDALE GETTYSBURG LP in 3710 OXFORD ROAD, GETTYSBURG, PA 17325 (NAICS 112310). OSHA activity number 338525835.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- HILLANDALE GETTYSBURG LP
- Site address
- 3710 OXFORD ROAD
- City
- GETTYSBURG
- State
- PA
- ZIP
- 17325
- Mailing
- 3910 OXFORD ROAD, GETTYSBURG, PA 17325
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 112310
- Employees
- 30
- Ownership type
- A
Citations
3 citations on file for this inspection.
5(a)(1)
- Issued
- May 2, 2013
- Abate by
- May 29, 2013
- Penalty
- Initial $6,300 · Current $3,780 Reduced
General-duty citation text
OSH ACT of 1970 Section (5)(a)(1): The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to fall hazards: (a) The stairways in houses 11 and 12 were not provided with standard stair rails, exposing employees to fall hazards. One feasible and acceptable method of abatement is to install standard stair rails along the open sides of all stairs in the egg laying houses in accordance with ANSI A1264.1 (Safety Requirements for Workplace Floor and Wall Openings, Stairs and Railing Systems) paragraph 5.5. (b) Employees were exposed to fall hazards of seven feet when overhead rollup doors located on the upper levels of the egg laying houses were open. One feasible and acceptable method of abatement is to install standard guard rails along the wall openings outside of the doors on the upper level of the egg laying houses in accordance with ANSI A1264.1 (Safety Requirements for Workplace Floor and Wall Openings, Stairs and Railing Systems) paragraph 4. Abatement certification required within 10 days after abatement date. The certification shall include a statement that abatement is complete, date and method of abatement, and states employees and their representatives were informed of this abatement.
Recent events (2)
- — I (S) $3780
- — Z (S) $6300
1910.242 B
- Issued
- May 2, 2013
- Abate by
- May 29, 2013
- Penalty
- Initial $2,700 · Current $1,620 Reduced
General-duty citation text
29 CFR 1910.242(b): Compressed air used for cleaning purposes was not reduced to less than 30 p.s.i.: (a) Outside Generator Room - Employees cleaned their clothing with a blow down nozzle that delivered 50 p.s.i. on or about January 29, 2013. Abatement certification required within 10 days after abatement date. The certification shall include a statement that abatement is complete, date and method of abatement, and states employees and their representatives were informed of this abatement.
Recent events (2)
- — I (S) $1620
- — Z (S) $2700
1910.303 G01 I B
- Issued
- May 2, 2013
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.303(g)(1)(i)(B): For electric equipment operating at 600 volts, nominal, or less to ground, and likely to require examination, adjustment, servicing, or maintenance while energized, the width of the working space in front of electrical equipment was less than the width of the equipment or 762 mm (30 inches), whichever was greater : (a) Generator room - The employer did not maintain a clear space in front of the electrical motor controller panel for generator number 1 and number 2 on or about January 29, 2013. Abatement certification required within 10 days after abatement date. The certification shall include a statement that abatement is complete, date and method of abatement, and states employees and their representatives were informed of this abatement.
Recent events (2)
- — I (O) $0
- — Z (O) $0
More inspections at Hillandale Gettysburg LP
View Hillandale Gettysburg LP's full OSHA safety record →
More inspections in this industry (NAICS 112310)
More inspections in PA
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 338525835.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.