Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: ANGEL RODRIGUEZ

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of ANGEL RODRIGUEZ in 131/135 TINLEY PARK CIRCLE, DELAWARE, OH 43015 (NAICS 238130). OSHA activity number 338634645.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Angel Rodriguez — free Get an email when a new federal OSHA severe-injury report for Angel Rodriguez is published. One employer, no account, unsubscribe in one click.
Establishment
ANGEL RODRIGUEZ
Site address
131/135 TINLEY PARK CIRCLE
City
DELAWARE
State
OH
ZIP
43015
Mailing
1823 LITTLE AVENUE, COLUMBUS, OH 43223
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
10
Ownership type
A

4 citations on file for this inspection.

1926.405 G02 IV

Serious Gravity 5 1 instance 3 exposed
Issued
Mar 18, 2013
Abate by
Mar 28, 2013
Penalty
Initial $1,600 · Current $1,600
29 CFR 1926.405(g)(2)(iv):     Strain relief. Flexible cords shall be connected to devices and fittings so that strain relief is provided which will prevent pull from being directly transmitted to joints or terminal screws.          a)     On or about January 31, 2013, at the worksite, the employer did not ensure that the circular saw that was used by employees had strain relief on the cord, thereby exposing employees to a potential shock hazard.
Recent events (1)
  • — Z (S) $1600

1926.501 B04 I

Serious Gravity 5 1 instance 5 exposed
Issued
Mar 18, 2013
Abate by
Mar 28, 2013
Penalty
Initial $2,000 · Current $2,000
29 CFR 1926.501(b)(4)(i):     Each employee on walking/working surfaces shall be protected from falling through holes (including skylights) more than 6 feet (1.8 m) above lower levels, by personal fall arrest systems, covers, or guardrail systems erected around such holes.          a)     On or about January 31, 3013, at the worksite, by the front entry area, the employer did not ensure that the floor hole, leading to the basement area was adequately guarded.
Recent events (1)
  • — Z (S) $2000

1926.501 B13

Serious Gravity 10 1 instance 3 exposed
Issued
Mar 18, 2013
Abate by
Mar 28, 2013
Penalty
Initial $2,800 · Current $2,800
29 CFR 1926.501(b)(13):     "Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure. Exception: When the employer can demonstrate that it is infeasible or creates a greater hazard to use these systems, the employer shall develop and implement a fall protection plan which meets the requirements of paragraph (k) of 1926.502.          a)     On or about January 31, 2013, at the workplace, the employer did not ensure that employees performing framing work were provided and used fall protection while working at heights greater than six feet, thereby exposing employees to an approximate 21 foot fall hazard.
Recent events (1)
  • — Z (S) $2800

1926.1053 B01

Serious Gravity 5 1 instance 3 exposed
Issued
Mar 18, 2013
Abate by
Mar 28, 2013
Penalty
Initial $1,600 · Current $1,600
29 CFR 1926.1053(b)(1):     When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support.          a)     On or about January 31, 2013, at the worksite, the employer did not ensure that the extension ladder that was used to access and/or exit the roof area was extended at least three feet above the working/walking surface area of the roof sheathing, thereby exposing employees to a potential trip fall hazard.
Recent events (1)
  • — Z (S) $1600

View Angel Rodriguez's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 338634645.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.