KILLDEER, ND ·
OSHA Inspection: SUN WELL SERVICE, INC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of SUN WELL SERVICE, INC. in CEDAR 148-94-12D-01-4H TF, KILLDEER, ND 58640 (NAICS 213112). OSHA activity number 339027088.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- SUN WELL SERVICE, INC.
- Site address
- CEDAR 148-94-12D-01-4H TF
- City
- KILLDEER
- State
- ND
- ZIP
- 58640
- Mailing
- P.O. BOX 2356, WILLISTON, ND 58802
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (B)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 213112
- Employees
- 500
- Ownership type
- Private (A)
Citations
1 citation on file for this inspection.
5(a)(1)
- Issued
- Jun 25, 2013
- Abate by
- Jun 28, 2013
- Penalty
- Initial $5,000 · Current $2,750 Reduced
General-duty citation text
Section 5(a)(1): The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to fall and fire/explosion hazards: (a) On or about April 26, 2013, for three employees exposed to fall and fire/explosion hazards where the Geronimo line was secured with only one saddle clamp to its anchor point at the well site identified as the Cedar 148-94-12D-01-4H TF on Rig #24 near Killdeer, ND. (b) On or about April 26, 2013, for three employees exposed to fire and explosion hazards where the Geronimo line was hooked on the opposite side of the derrickman's platform approximately seven feet from where the employees were working at the well site identified as Cedar 148-94-12D-01-4H TF on Rig #24 near Killdeer, ND. Abatement Note: Among other methods, feasible and acceptable abatement methods to correct the hazard would be for the employer to correctly install and secure the "Geronimo" safety slide ground anchor cable by using at least three (API) American Petroleum Institute approved cable clamps in accordance with Geronimo Manufacturing, Inc. Operators Manual, pages 9-11, "INSTALLATION", Illustrations 2 and 3, and "Do not force your crew to have to climb over anything to gain access to the Geronimo unit."
Recent events (2)
- · I (S) $2750
- · Z (S) $5000
More inspections at SUN Well Service, INC.
View SUN Well Service, INC.'s full OSHA safety record →
More inspections in this industry (NAICS 213112)
More inspections in ND
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 339027088.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.