Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,197,124Inspections Most recent open 2026-08-25 Last loaded 2026-08-28

OSHA Inspection: R&M FABRICATORS, INC.

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of R&M FABRICATORS, INC. in 318 MALL BOULEVARD, SAVANNAH, GA 31406 (NAICS 238120). OSHA activity number 339485799.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch R&M Fabricators, INC. for free Get an email when a new federal OSHA severe-injury report for R&M Fabricators, INC. is published. One employer, no account, unsubscribe in one click.
Site address
318 MALL BOULEVARD
City
SAVANNAH
State
GA
ZIP
31406
Mailing
3117 ROGERS ROAD, GLENNVILLE, GA 30427
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
Non-union (B)
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238120
Employees
4
Ownership type
Private (A)

1 citation on file for this inspection.

1926.760 A01

Serious Gravity 10 1 instance 1 exposed
Issued
Jan 24, 2014
Penalty
Initial $2,800 · Current $1,400 Reduced
29 CFR 1926.760(a)(1): Except as provided by paragraph (a)(3) of this section, each employee engaged in a steel erection activity who is on a walking/working surface with an unprotected side or edge more than 15 feet (4.6 m) above a lower level shall be protected from fall hazards by guardrail systems, safety net systems, personal fall arrest systems, positioning device systems or fall restraint systems.    a). Kroger Fuel Center Canopy- On or about 14 November 2013, an employee working on the canopys roof while installing upright brackets onto the deck pans was not protected from falling by the use of a fall protection system, thus exposing the employee to a fall hazard of approximately 16.6 feet onto earthen ground.
Recent events (2)
  • · I (S) $1400
  • · Z (S) $2800

View R&M Fabricators, INC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 339485799.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.