SIDNEY, NY —
OSHA Inspection: AMPHENOL CORPORATION
Complaint inspection · Health discipline
At a glance
On , OSHA opened a complaint health inspection of AMPHENOL CORPORATION in 40-60 DELAWARE AVENUE, SIDNEY, NY 13838 (NAICS 334417). OSHA activity number 339662546.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- AMPHENOL CORPORATION
- Site address
- 40-60 DELAWARE AVENUE
- City
- SIDNEY
- State
- NY
- ZIP
- 13838
- Mailing
- 40-60 DELAWARE AVENUE, SIDNEY, NY 13838
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Health
- Advance notice
- No
- Union status
- A
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 334417
- Employees
- 800
- Ownership type
- A
Citations
5 citations on file for this inspection.
1910.23 C01
- Issued
- May 30, 2014
- Penalty
- Initial $3,400 · Current $2,380 Reduced
General-duty citation text
29 CFR 1910.23(c)(1): Open sided floor(s) or platform(s) 4 feet or more above the adjacent floor or ground level were not guarded by standard railings (or the equivalent as specified in 29 CFR 1910.23(e)(3)(i) through (v)), on all open sides: a) Mezzanine Above Guage Inspection, on or about 4/8/14: Work platform was not guarded by a standard railing along the open side exposing employees to a 12 foot fall hazard.
Recent events (2)
- — I (S) $2380
- — Z (S) $3400
1910.212 A01
- Issued
- May 30, 2014
- Penalty
- Initial $2,550 · Current $1,785 Reduced
General-duty citation text
29 CFR 1910.212(a)(1): One or more methods of machine guarding was not provided to protect the operator and other employees in the machine area from hazards such as those created point of operation, rotating parts, and flying chips: a) Electrical Maintenance Room for Department 52, on or about 4/8/14: Wilton Drill Press was not provided with a chuck and tool guard.
Recent events (2)
- — I (S) $1785
- — Z (S) $2550
1910.219 D01
- Issued
- May 30, 2014
- Penalty
- Initial $2,550 · Current $1,785 Reduced
General-duty citation text
29 CFR 1910.219(d)(1): Pulley(s) with part(s) seven feet or less from the floor or work platform were not guarded in accordance with the requirements specified in 29 CFR 1910.219(m) and (o): a) Tumbler Area, on or about 4/8/14: The Shaker Table was not provided with a guard over the in-running nip points of the belt and pulley drive.
Recent events (2)
- — I (S) $1785
- — Z (S) $2550
1910.219 E01 I
- Issued
- May 30, 2014
- Penalty
- Initial $0 · Current $0
General-duty citation text
29 CFR 1910.219(e)(1)(i): Horizontal belts which had both runs 42 inches or less from the floor level were not fully enclosed by guards conforming to requirements specified in 29 CFR 1910.219(m) and (o): a) Tumbler Area, on or about 4/8/14: The Shaker Table was not provided with a guard over the in-running nip points of the belt and pulley drive.
Recent events (2)
- — I (S) $0
- — Z (S) $0
1910.303 B02
- Issued
- May 30, 2014
- Penalty
- Initial $2,550 · Current $1,785 Reduced
General-duty citation text
29 CFR 1910.303(b)(2): Listed or labeled electrical equipment was not used or installed in accordance with instructions included in the listing or labeling: a) Electrical Maintenance Room for Department 53, on or about 4/8/14: : Employees using duplex metal outlet box connected to a flexible cord that was not in accordance with UL approval. Box is listed for permanent mounting only. b) Tumbler Area, on or about 4/8/14: : Employees using duplex metal outlet box connected to a flexible cord that was not in accordance with UL approval. Box is listed for permanent mounting only. c) Bechlar Area, on or about 4/8/14: : Employees using a quad metal outlet box and a duplex metal outlet box connected to flexible cords that were not in accordance with UL approval. Boxes are listed for permanent mounting only.
Recent events (2)
- — I (S) $1785
- — Z (S) $2550
More inspections at Amphenol Corporation
View Amphenol Corporation's full OSHA safety record →
More inspections in this industry (NAICS 334417)
More inspections in NY
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 339662546.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.