DOVER, OH —
OSHA Inspection: GE LIGHTING DOVER PRODUCTS
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of GE LIGHTING DOVER PRODUCTS in 200 WEST BROADWAY STREET, DOVER, OH 44622 (NAICS 335110). OSHA activity number 339856015.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- GE LIGHTING DOVER PRODUCTS
- Site address
- 200 WEST BROADWAY STREET
- City
- DOVER
- State
- OH
- ZIP
- 44622
- Mailing
- 200 WEST BROADWAY STREET, DOVER, OH 44622
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- A
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 335110
- Employees
- 62
- Ownership type
- A
Citations
2 citations on file for this inspection.
5(a)(1)
- Issued
- Oct 7, 2014
- Abate by
- Oct 25, 2014
- Penalty
- Initial $3,400 · Current $2,380 Reduced
General-duty citation text
OSH ACT of 1970 Section (5)(a)(1): The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees a. Located in the General Fabrication Department, there were Campbell screw-adjusted cam (SAC) clamps used in the lifting of tungsten material that had a Rockwell hardness greater than 43. The tungsten material was too hard for hoisting with the SAC clamps, thereby exposing the employees to a struck-by hazard.
Recent events (4)
- — I $0
- — Z $28000
- — I (S) $2380
1910.212 A01
- Issued
- Oct 7, 2014
- Penalty
- Initial $4,250 · Current $2,975 Reduced
General-duty citation text
29 CFR 1910.212(a)(1)The point of operation of machines whose operation exposes an employee to injury, shall be guarded. The guarding device shall be in conformity with any appropriate standards therefor, or, in the absence of applicable specific standards, shall be so designed and constructed as to prevent the operator from having any part of his body in the danger zone during the operating cycle. a. Located in the General Fabrication Department, employees operated a vertical HE&M saw, model number V100HLM-3, serial number 887205 in order to cut tungsten rings. The saw had its telescopic guarding retracted and secured with a broken thumb set screw which did not allow for employees to extend the guard over the blade, thereby exposing the employees to an amputation and/or laceration hazard from the unguarded blade.
Recent events (2)
- — I (S) $2975
- — Z (S) $4250
More inspections at GE Lighting Dover Products
View GE Lighting Dover Products's full OSHA safety record →
More inspections in this industry (NAICS 335110)
More inspections in OH
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 339856015.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.