Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: UNGERER & COMPANY

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of UNGERER & COMPANY in 110 N COMMERCE WAY, BETHLEHEM, PA 18017 (NAICS 311942). OSHA activity number 341169845.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Ungerer & Company — free Get an email when a new federal OSHA severe-injury report for Ungerer & Company is published. One employer, no account, unsubscribe in one click.
Establishment
UNGERER & COMPANY
Site address
110 N COMMERCE WAY
City
BETHLEHEM
State
PA
ZIP
18017
Mailing
110 N COMMERCE WAY, BETHLEHEM, PA 18017
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
311942
Employees
111
Ownership type
A

4 citations on file for this inspection.

5(a)(1)

Serious Gravity 1 1 instance 1 exposed
Issued
May 25, 2016
Penalty
Initial $2,550 · Current $1,800 Reduced
OSH ACT of 1970 Section (5)(a)(1): Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to fall hazards while using improperly maintained mobile ladder stands.    a) Unger & Company, Spray Dry Room - On or about January 27, 2016, a mobile ladder stand being used by employees was not properly fitted with the rubber pad safety stops required to prevent horizontal movement when the ladder was in use.    ABATEMENT NOTE:  Among other methods, one feasible and acceptable abatement method to correct this hazard is: Comply with the manufacturer's requirements and ANSI A14.7-1991 for Mobile Ladder Stands and discontinue use until repairs are completed. Section 4.3.7 states, "Units which use wheels or casters, ridged and / or swivel, shall be equipped with a system to prevent the unit from horizontal movement". Section 6.3 also states, "Units that are damaged or weakened from any cause shall not be used until repairs are completed",  Units that are damaged subsequent to their receipt, and/or are worn beyond repair shall be destroyed. Never climb a damaged ladder stand or ladder".
Recent events (2)
  • — I (S) $1800
  • — Z (S) $2550

5(a)(1)

Serious Gravity 5 1 instance 2 exposed
Issued
May 25, 2016
Abate by
Jun 10, 2016
Penalty
Initial $4,250 · Current $3,500 Reduced
OSH ACT of 1970 Section (5)(a)(1): Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to fire and or explosion hazards.    a) Ungerer & Company. - On or about January 27, 2016, employees were operating a Dustkop Brand FT40/20E31 Dust Collection Unit in the dry blend room that was located inside the building without being vented to the outside or provided with proper explosion suppression systems.
Recent events (2)
  • — I (S) $3500
  • — Z (S) $4250

1910.307 C02 I

Serious Gravity 5 1 instance 2 exposed
Issued
May 25, 2016
Abate by
Jun 10, 2016
Penalty
Initial $4,250 · Current $3,540 Reduced
29 CFR 1910.307(c)(2)(i): Equipment in hazardous (classified) location(s) was not approved for the class of location:    a) Ungerer & Company. - On or about January 27, 2016, employees were using a Ridgid brand Model WDI14500 electric shop vacuum that is not approved for hazardous locations to clean up Class II Combustible Dust.
Recent events (2)
  • — I (S) $3540
  • — Z (S) $4250

1910.147 C06 I

Other-than-serious 1 instance 1 exposed
Issued
May 25, 2016
Abate by
Jun 10, 2016
Penalty
Initial $0 · Current $0
29 CFR 1910.147(c)(6)(i): The employer did not conduct a periodic inspection of the energy control procedure at least annually to ensure that the procedure and the requirement of this standard were being followed:  a) Ungerer & Company. - On or about January 27, 2016, the employer did not conduct a periodic inspection of their energy control procedure since February 16, 2007 to ensure that the procedure and the requirements of the OSHA standards were being followed.
Recent events (2)
  • — I (O) $0
  • — Z (O) $0

View Ungerer & Company's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 341169845.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.